Dinel RFLS-53N Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Poziomica laserowa Dinel RFLS-53N. Dinel RFLS-53N 16 stron. High frequency level switch

7 . s

etting

Setting-up can be performed with a "MP–8" magnetic pen that is a part of of the delivery.

Settings are performed by touching a magnetic pen on sensitive spot indicated as

located beside the connector or cable gland.

1) Setting the Normally Open or Normally Closed switching mode:

Factory default mode is Normally Open. If the setting mode satisfies, you can skip next steps.

Setting the sensor to Normally Closed mode:

1. Disconnect the sensor from the power source (e.g. by disconnecting the connector).

2. Place the magnetic pen on

3. Connect the power supply. Green and Orange LED lights up.

4. Take the magnetic pen away.

• Other settings of the sensor remain unchanged.

• Repeating this procedure will set the switching mode Normally Open again.

2) Adjusting sensitivity by short touch of magnetic pen (approx. 0,5 sec) to:

spot: increase sensitivity (every step is confirmed by 3-times flashing green LED)

spot: decrease sensitivity (every step is confirmed by 3-times flashing green LED)

•

When the end of sensitivity range is reached (min or max sensitivity), the frequency of

green LED flashing slows down.

•

Verify the function by activation of the sensor and watch the sensor behavior.

•

The sensor is factory default set to basic sensitivity.

3) Factory default mode:

factory mode is Normally Open, setting of sensitivity is for materials about ε

1. Disconnect the sensor from the power source (e.g. by disconnecting the connector).

2. Place the magnetic pen on

3. Connect the power supply. Green and Orange LED lights up.

4. Take the magnetic pen away.

5. Now is Factory default mode set.

Valve connector

Safety screw

spot marked

Fig. 6: Full view of capacitive level switch

spot in the voltage-free state and hold it.

Cable gland

spot marked

LED indicators

= 2.

RFLS–53