Aeotec AEOEZW112 Skrócona instrukcja obsługi

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Akcesoria Aeotec AEOEZW112. Aeotec AEOEZW112 6 stron.

Aeotec

Door/ Window Sensor 6

SKU: AEOEZW112

Quickstart

This is a secure Alarm Sensor for Europe. To run this device please insert fresh 1 * internal Lithium batteries. Please make sure the internal battery is fully

charged. Turn the primary controller into inclusion mode, short press the product?s Action Button that you can ﬁnd in the back of the product.

Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer,

distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this

equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a ﬁre or near open heat sources.

What is Z-Wave?

Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section

Z-Wave ensures a reliable communication by reconﬁrming every message (two-way communication) and

every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is not

in direct wireless range of the transmitter.

This device and every other certiﬁed Z-Wave device can be used together with any other certiﬁed Z-Wave

device regardless of brand and origin as long as both are suited for the same frequency range.

If a device supports secure communication it will communicate with other devices secure as long as this

device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of

security to maintain backward compatibility.

For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.

Product Description

Aeon Labs Door/ Window Sensor 6 is a smart Z-Wave sensor that can detect the status of door/window"s open/close in real time.

It?s a security Z-Wave device that supports security encryption. Also it supports the ?Over the Air Firmware Updating? that allows you wirelessly update its ﬁrmw

needs.

It can be included and operated in any Z-Wave network with other Z-Wave certiﬁed devices from manufacturers and/or other applications.

Prepare for Installation / Reset

Please read the user manual before installing the product.

In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do

by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to

the primary controller of the previous network to make sure the very device is excluded properly from this network.

Reset to factory default

This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only be used when the primary controller is inoperable

Press the Action Button once that you can ﬁnd in the back of the product for 20 seconds and then release. This procedure should only be used when the primary

controller is inoperable.

Safety Warning for Batteries

The product contains batteries. Please remove the batteries when the device is not used. Do not mix batteries of different charging level or different brands.

http://manual.zwave.eu/backend/make.php?lang=en&sku=AEOEZW112

30-09-2020 13:12

Pagina 1 van 6