Aeotec Door / Window Sensor 7 Skrócona instrukcja obsługi - Strona 5
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Akcesoria Aeotec Door / Window Sensor 7. Aeotec Door / Window Sensor 7 11 stron.
Również dla Aeotec Door / Window Sensor 7: Podręcznik użytkownika (9 strony), Podręcznik użytkownika (9 strony), Podręcznik użytkownika (10 strony)
Drukuj stronę
2. If inclusion still fails, check if both devices use the same frequency.
3. Remove all dead devices from associations. Otherwise you will see severe delays.
4. Never use sleeping battery devices without a central controller.
5. Dont poll FLIRS devices.
6. Make sure to have enough mains powered device to benefit from the meshing
Firmware-Update over the Air
This device is capable of receiving a new firmware 'over the air'. The update function needs to be
supported by the central controller. Once the controller starts the update process, perform the following
action to confirm the firmware update: Wake Up the device by removing the cover. Then hit the tamper
switch once.
Association - one device controls another device
Z-Wave devices control other Z-Wave devices. The relationship between one device controlling another
device is called association. In order to control a different device, the controlling device needs to maintain
a list of devices that will receive controlling commands. These lists are called association groups and
they are always related to certain events (e.g. button pressed, sensor triggers, ...). In case the event
happens all devices stored in the respective association group will receive the same wireless command
wireless command, typically a 'Basic Set' Command.
Association Groups:
Group Number
1
2
3
4
Configuration Parameters
Z-Wave products are supposed to work out of the box after inclusion, however certain configuration can
adapt the function better to user needs or unlock further enhanced features.
IMPORTANT: Controllers may only allow configuring signed values. In order to set values in the range
128 ... 255 the value sent in the application shall be the desired value minus 256. For example: To set a
parameter to 200 i t may be needed to set a value of 200 minus 256 = minus 56. In case of a two byte
value the same logic applies: Values greater than 32768 may needed to be given as negative values too.
Parameter 3: Door/window state
This parameter allows to set in what state is door/window when the magnet is close to the sensor.
Size: 1 Byte, Default Value: 0
Maximum
Description
Nodes
5
Lifeline
5
Control devices when a magnet is tripped.
5
Sends out alarm message when a magnet is tripped
5
Sends alarm messages when tamper is tripped