Aeotec MultiSensor 7 Podręcznik użytkownika - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Akcesoria Aeotec MultiSensor 7. Aeotec MultiSensor 7 8 stron.
Również dla Aeotec MultiSensor 7: Podręcznik użytkownika (5 strony)
Drukuj stronę
22/07/2021
3. It will be solid yellow during inclusion, and flash white/green 3 times if paired successfully. If it fails, it will
flash
/red
Advanced Functions.
Z-Wave Resetting MultiSensor 7.
Your MultiSensor can be removed from your Z-Wave network at any time. You'll need to use your Z-Wave network's
main controller to do this and the following instructions tell you how to do this. If you are using other products as your
main Z-Wave controller, please refer to the part of their respective manuals that tells you how remove devices from
your network.
Using an existing gateway:
You may need to refer to your gateway's method of including devices if you do not know how to pair a Z-Wave
device. You may use any gateway to perform an unpair/removal on MultiSensor 7 even if they are not paired
together to factory reset MultiSensor 7.
1.
Z W
2. Tap the action button once; the purple led will light up.
3. If removed successful, the blue led will fade in and out to indicate it is ready to be paired to a new hub.
Manual Hard Resetting MultiSensor 7.
This method is not fully advised unless your gateway has failed, if paired to your network, performing these steps will
factory reset your MultiSensor 7, but may leave a hard to remove phantom/ghost device in your working Z-Wave
network.
1. Make sure the device has been powered.
2. Press and hold the button for 20 seconds. When the red led flash, the device will enter factory reset mode.
https://aeotec.freshdesk.com/support/solutions/articles/6000232605-multisensor-7-user-guide
instead.
Z W
MultiSensor 7 user guide : Aeotec Help Desk
6/8