Ariston PRIMO HE ITSI 300 Instrukcje instalacji, serwisowania i obsługi - Strona 32

Przeglądaj online lub pobierz pdf Instrukcje instalacji, serwisowania i obsługi dla Podgrzewacz wody Ariston PRIMO HE ITSI 300. Ariston PRIMO HE ITSI 300 34 stron. Unvented hot water storage cylinders

Drukuj stronę

BENCHMARK COMMISSIONING CHECKLIST

I M A I N S P R E S S U R E H O T W A T E R S T O R A G E S Y S T E M C O M M I S S I O N I N G C H E C K L I S T

This Commissioning Checklist is to be completed in full by the competent person who commissioned the boiler as a means of demonstrating

compliance with the appropriate Building Regulations and then handed to the customer to keep for future reference.

Failure to install and commission this equipment to the manufacturer's instructions may invalidate the warranty but does not affect statutory rights.

Customer Name

Telephone Number

Boiler Make ar^d Model

Boiler Serial Number I I I 1 I 1 I I 1 1 I I I I I I 1 I I I ! I I 1 1 I I I I I I I I I I 1 I I I I

Commissioned by print rtame)

CORGI ID Number

Company Name

Telephone Number

Company Address

Commissioning Date

To be completed by the customer on receipt of a Building Regulations Compliance Certificate*:

Building Regulations Notification Number (if applicable)

ALL SYSTEMS PRIMARY SETTINGS (indirect heating only)

is the primary circuit a sealed or open vented system?

What Is the maximum primary flow temperature?

ALL SYSTEMS

What is the incoming static cold water pressure at the inlet to the system?

Has a strainer been cleaned of Installation debris (if fitted)?

Yes

Is the installation in a hard water area (above 200ppm)?

Yes

If yes, has a water scale reducer been fitted?

Yes

□

What type of scale reducer has been fitted?

Time and temperature controls have been fitted in compliance with Part L of the Building Regulations?

Type of control system (if applicable)

Is the cylinder solar (or other renewable) compatible?

What is the hot water temperature at the nearest outlet?

What is the pressure reducing valve setting?

Has a combined temperature and pressure relief valve and expansion valve been fitted and discharge tested?

The tundish and discharge pipework have been connected and terminated to Part G of the Building Regulations

Are all energy sources fitted with a cut out device?

Has the expansion vessel or internal air space been checked?

THERMAL STORES ONLY

What store temperature is achievable?

What is the maximum hot water temperature?

ALL INSTALLATIONS

>3 The hot water system complies with the appropriate Building Regulations

The system has been installed and commissioned in accordance with the manufacturer's instructions

The system controls have t>een demonstrated to and understood by the customer

The manufacturer's literature, including Benchmark Checklist and Service Record, has been explained and left with the customer

Commissioning Engineer's Signature

Customer's Signature

(To contirm salisractory demonstration and racaipt o! manufacturer^ literature)

*AI1 InstailaUons In Ensland and V^tes must be notified to Local Authority Building Control (LABC) ^her directly or through a Competent Persons Scheme.

A BuiKfing Bssulatlona Compliance Certincate will then be issued to the customer.

benchmark

GHeating and Hotwater Industry Council (HHIC)

vwvw.centridheatlng.co.uk