Aeotec ZWA019 Podręcznik użytkownika - Strona 3
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Akcesoria Aeotec ZWA019. Aeotec ZWA019 9 stron. Water sensor
Również dla Aeotec ZWA019: Podręcznik (3 strony), Podręcznik użytkownika (9 strony), Podręcznik użytkownika (13 strony)
Drukuj stronę
17/06/2021
Quick Start
Installation of Water Sensor 7 Pro.
Open the cover by pressing the clip on the side and pulling the cover upwards.
Insert a fresh 1 * 1/2 AA battery, but pay attention to the polarity
Install your Water Sensor 7 Pro.
The Water Sensor 7 should be placed wherever you want to monitor for possible flooding or leaks. When placing the
Water Sensor 7, consider the direction in which a flood or leak may flow and where it may occur. The contacts of the
Water Sensor 7 probe will detect the liquid, so the probe must be placed so that any flood or leak will come into contact
with it. When the probe contacts come into contact with a liquid, the Water Sensor 7 sends a leak warning to your Z-
Wave Gateway. Make sure that both contacts are capable of detecting leaks or flooding.
Adding your Water Sensor 7 to Z-Wave network.
Y
Z W
W
Classic Inclusion
1. Set your Z-Wave controller into pairing mode.
2. Triple-click the tamper switch on Water Sensor 7 - this begins to blink five times
3. After completion of the inclusion, the LED will illuminate green for 3 seconds.
4. If you pairing with S2 encryption/security, enter the first 5 digits of the DSK into your controller/gateway/hub
interface when requested.
5. Close the cover
https://help.aeotec.com/support/solutions/articles/6000235950-water-sensor-7-pro-user-guide-zwa019-zwa044-
Water Sensor 7 Pro user guide (ZWA019/ZWA044) : Aeotec Help Desk
Z W
W
W
Z W
3/9