3Com 3C16075 Instrukcja instalacji - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt sieciowy 3Com 3C16075. 3Com 3C16075 12 stron. Superstack 3 advanced rps type 3 power module
Drukuj stronęCAUTION: Wenn sich das Type 3 Power Module im Advanced RPS
Chassis befindet kann es zu einer Energiegefahr am DC Stecker
kommen.
Installing the Power Module
CAUTION: Never plug a hot power module into the Advanced RPS.
You may damage the power module. Allow sufficient time
(approximately 1 minute) for the module to cool down before
inserting it into the power module slot.
CAUTION: It is important that the power modules are cooled
effectively. We strongly recommend installing the power modules as
evenly as possible between the top and bottom slots. Refer to Table 1
for recommendations on slot configurations for the Type 3 Module.
You can "hot-insert" the Type 3 Module into the chassis, that is, you
do not need to remove mains power from the chassis before you
insert a power module.
1 Take off the blanking plate by removing the fixing screw. Keep the
blanking plate and screw in a safe place. If you remove the module at
any time, you must replace the blanking plate to maintain the flow of
cooling air within the chassis.
2 Hold the power module so that the text on the front panel is upright,
and insert it into the chassis, sliding the module into the runners.
Push firmly to ensure the connectors are fully engaged.
3 Secure the module with the screws provided using a suitable tool.
CAUTION: When removing a power module that has just been
operating, beware of hot components.
CAUTION: Do not operate the Advanced RPS continuously with any
of the rear slots open. This will disturb the flow of cooling air and
reduce the life of your unit.
Installing the Power Module
9