Fireline FXi Instrukcja instalacji i obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Kuchenka Fireline FXi. Fireline FXi 16 stron. Taper multi fuel stove insert
Również dla Fireline FXi: Instalacja i instrukcje obsługi (16 strony), Instrukcja szybkiej instalacji (2 strony)
Drukuj stronęWood burns most efficiently with the primary air controls closed and the secondary (air
wash) controls a small amount open. Carefully adjusting the fuel load and secondary air
controls will then control the burn rate of the stove. Always make sure that flames are
visible above the wood after re-fuelling for cleanest burning. Open the air wash full for 3
to 5 minutes after re-fuelling to achieve full flames above the fuel.
Wood burns best on a bed of ash and it is therefore only necessary to remove surplus
ash from the stove occasionally.
Burn only dry, well-seasoned wood, which should have been cut, split and stacked -
under protection from rain - for at least 12-24 months with free air movement around the
sides of the stack to enable it to dry out. Burning wet or unseasoned wood will create tar
deposits in the stove and chimney and will not produce a satisfactory heat output. Wood
that is not properly dry ('dry' is considered to be less than 20% internal moisture
content) uses up energy from the burn process to evaporate the water inside the
wood thus creating very poor conditions for combustion. The main cause of
burning problems with wood stoves is due to excessively damp wood. Wood can appear
perfectly dry on the outside but still contain 40-50% water on the inside. A moisture
meter can be purchased from stove and equipment suppliers if you wish to check your
wood source is correct.
6.5.1 Refuelling on to a low fire bed
If there is insufficient burning material in the fire bed to light a new fuel charge,
excessive smoke emission can occur. Refuelling must be carried out onto a sufficient
quantity of glowing embers and ash so that the new fuel charge will ignite in a
reasonable period. If there are too few embers in the fire bed, add suitable kindling to
prevent excessive smoke.
6.5.2 Fuel overloading
The maximum amount of fuel specified in this manual should not be exceeded,
overloading can cause excess smoke.
6.5.3 Operation with door left open
Operation with the door open can cause excess smoke and spillage into the room. The
appliance must not be operated with the appliance door left open.
6.5.4 Primary Air left open
Operation with the primary air controls left open can cause excess smoke. The
appliance must not be operated with air controls or door left open.
6.6 Notes on Smokeless Fuel (Ancit) burning
Ancit, smokeless and coal type fuels require very different burning conditions to log
burning. When the stove is established and burning well, the air wash can be closed
fully and the burning rate controlled with the primary air control and refuelling to obtain
maximum efficiency. Ancit and other smokeless briquetted fuels can burn with very little
primary air and stay in for many hours.
6.7 Lighting the Stove
We recommend that you have two or three small fires before you operate your stove to
its maximum heat output. This is to allow the paint to cure in steadily and to give a long
service life of the paint finish. During this curing in process you may notice an
unpleasant smell whilst the finishes finally cure. It is non-toxic, but for your comfort we
would suggest that during this period you leave all doors and windows open.
FXiT.FPiT.FGiT
10
Issue 02 10/12