Whirlpool WFW9351YW Instrukcja obsługi i konserwacji - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Spryskiwacz Whirlpool WFW9351YW. Whirlpool WFW9351YW 48 stron. Clothes washer
Również dla Whirlpool WFW9351YW: Podręcznik dotyczący energii (2 strony)
Drukuj stronę
11.
Remove garments promptly
after cycle is finished
Promptly remove garments after cycle has
completed to avoid odor and rusting of
metal objects on garments. When unloading
garments, pull back the door seal and check
for small items between the tub and the basket.
If you will be unable to remove the load promptly, use
the TumbleFresh
option to automatically tumble the load
™
periodically for up to 6 hours.
NOTE:
After any wash cycle is completed, the door must be
n
opened and then closed before a new cycle can begin.
A small amount of water may remain in the dispensers
n
after the wash cycle is complete. This is normal.
This washer has a tight seal to avoid water leaks. To
n
avoid odors, leave the door open to allow the washer
to dry between uses.
12
WASHER MAINTENANCE
CLEANING YOUR WASHER
Keep your washer as clean and fresh as your clothes.
To keep washer interior odor-free, follow this recommended
cleaning procedure at least once a month:
1. Make sure laundry drum is empty.
2. Using recommended AFFRESH
one tablet to washer basket.
OR
If using liquid chlorine bleach, add 2/3 cup (160 mL) to
liquid chlorine bleach dispenser.
IMPORTANT: Do not add detergent to Clean Washer
with Affresh
cycle. Do not use more than recommended
®
amount of bleach to avoid damaging product over time.
3. Close washer door and dispenser drawer.
4. Press POWER.
5. Select CLEAN WASHER with AFFRESH
6. Press and hold START/PAUSE.
NOTE: The basket will rotate, then the door will unlock,
lock again, and then the cycle will continue. The washer will
not fill, and the basket will rotate while the washer runs a
short sensing cycle. This will take approximately 3 minutes.
7. The cycle will determine whether clothing or other items
are in the washer. If no items are detected in the washer,
it will proceed to Step 8.
If the Wash LED light flashes, the door will unlock.
Remove clothing or items in the washer. Press POWER
to cancel the flashing LED light. Then repeat steps 1, 2,
and 6 to start the cycle again.
8. Once the cycle has started, allow it to finish. If START/
PAUSE or POWER is pressed before the cycle is
complete, "Int" (Interrupted) will appear in the display.
It may take up to 10 minutes for the door to unlock.
9. After the cycle has ended, leave the door open slightly,
to allow for better ventilation and drying of washer
interior.
To clean exterior:
1. Use a soft, damp cloth or sponge to wipe up any spills.
2. Use mild soap and water if needed.
IMPORTANT: To avoid damaging washer finish, do not use
abrasive products.
washer cleaner, add
®
cycle.
®