Whirlpool 3LMVWC100 Instrukcja instalacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Spryskiwacz Whirlpool 3LMVWC100. Whirlpool 3LMVWC100 44 stron.

Drukuj stronę

ELECTRICAL REQUIREMENTS

A 220-240 volt, 50 Hz., AC only, 10-amp, fused electrical supply

is required. A time-delay fuse or circuit breaker is recommended.

It is recommended that a separate circuit breaker serving only this

appliance be provided.

This washer is equipped with a power supply cord having

an earthing plug.

To minimize possible shock hazard, the cord must be plugged

into a mating, earthing-type outlet, earthed in accordance with

local codes and ordinances. If a mating outlet is not available,

it is the personal responsibility and obligation of the customer

to have the properly earthed outlet installed by a qualified

electrician.

If codes permit and a separate earth wire is used, it is

recommended that a qualified electrician determine that

the earth path is adequate.

Do not earth to a gas pipe.

Check with a qualified electrician if you are not sure the

washer is properly earthed.

Do not have a fuse in the neutral or earth circuit.

When in the installed position, the mains plug must be

accessible for disconnection.

If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent, or similarly qualified persons

in order to avoid a hazard.

EARTHING INSTRUCTIONS

This washer must be earthed. In the event of a malfunction

or breakdown, earthing will reduce the risk of electric

shock by providing a path of least resistance for electric

current. This washer is equipped with a cord having an

equipment-earthing conductor and an earthing plug. The

plug must be plugged into an appropriate outlet that is

properly installed and earthed in accordance with all local

codes and ordinances.

WARNING:

Improper connection of the equipment-

earthing conductor can result in a risk of electric shock.

Check with a qualified electrician or serviceman if you are in

doubt as to whether the appliance is properly earthed.

Do not modify the plug provided with the appliance – if it will

not fit the outlet, have a proper outlet installed by a qualified

electrician.

INSTALLATION INSTRUCTIONS

Before you start: remove shipping materials

It is necessary to remove all shipping materials for proper

operation and to avoid excessive noise from washer.

Move washer

Move washer to within 1.2 m (4 ft) of its final location; it must

be in a fully upright position.

NOTE: To avoid floor damage, set washer onto cardboard

before moving it and make sure lid is taped shut.

Remove shipping base

To avoid damaging floor, place cardboard supports from

shipping carton on floor behind washer. Tip washer back and

place on cardboard supports. Remove shipping base. Set

washer upright.

IMPORTANT: Removing shipping base is necessary for proper

operation. If your washer includes a sound shield, please refer

to the instructions included with the sound shield to install it at

this time.