Whirlpool 3SWTW4800YQ Podręcznik - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik dla Spryskiwacz Whirlpool 3SWTW4800YQ. Whirlpool 3SWTW4800YQ 20 stron.
Również dla Whirlpool 3SWTW4800YQ: Instrukcja obsługi i konserwacji (28 strony)

Drukuj stronę
Whirlpool 3SWTW4800YQ Podręcznik

Electrical Requirements

A 230 volt, 50 Hz., AC only, 10-amp, fused electrical supply is
n
required. A time-delay fuse or circuit breaker is recommended.
It is recommended that a separate circuit breaker serving only
this appliance be provided.
This washer is equipped with a power supply cord having
n
a 3 prong grounding plug.
To minimize possible shock hazard, the cord must be plugged
n
into a mating, 3 prong, grounding-type outlet, grounded in
accordance with local codes and ordinances. If a mating outlet
is not available, it is the personal responsibility and obligation
of the customer to have the properly grounded outlet installed
by a qualified electrician.
If codes permit and a separate ground wire is used, it is
n
recommended that a qualified electrician determine that
the ground path is adequate.
Do not ground to a gas pipe.
n
Check with a qualified electrician if you are not sure the
n
washer is properly grounded.
Do not have a fuse in the neutral or ground circuit.
n
4

INSTALLATION INSTRUCTIONS

Before you start: remove shipping materials

It is necessary to remove all shipping materials for proper
operation and to avoid excessive noise from washer.
1.
Move washer
48"
(1.2 m)
Move washer to within 4 ft (1.2 m) of its final location; it must
be in a fully upright position.
NOTE: To avoid floor damage, set washer onto cardboard
before moving it and make sure lid is taped shut.
2.
Remove shipping base
To avoid damaging floor, place cardboard supports from
shipping carton on floor behind washer. Tip washer back and
place on cardboard supports. Remove shipping base. Set
washer upright.
IMPORTANT: Removing shipping base is necessary for proper
operation. If your washer includes a sound shield, please refer
to the instructions included with the sound shield to install it at
this time.