Whirlpool 4GWTW5500 Instrukcja obsługi i konserwacji - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Spryskiwacz Whirlpool 4GWTW5500. Whirlpool 4GWTW5500 50 stron. Top-loading high efficiency low-water washer

Drukuj stronę

TROUBLESHOOTING

First try the solutions suggested here to possibly avoid the cost of a service call.

if you experience

Possible Causes

Solution

Check the following for

Feet may not be in contact

Front and rear feet must be in firm contact with floor, and washer

proper installation or see

with the floor and locked,

must be level to operate properly. Jam nuts must be tight

"Using Your Washer"

against the bottom of the cabinet.

section.

Washer may not be level.

Check floor for flexing or sagging. If flooring is uneven, a 19 mm

(3/4") piece of plywood under your washer will reduce sound.

Clicking or metallic

noises

Gurgling or humming

Humming

Check the following for

proper installation:

Load could be unbalanced.

Objects caught in washer

drain system.

Washer may be draining water.

Load sensing may be

occurring

Washer not level.

Fill hoses not attached tightly.

Fill hose washers

Drain hose connection

Check household plumbing

for leaks or clogged sink or drain.

Washer not loaded properly.

Load not completely covered

in water.

See "Level the Washer" in the Installation Instructions.

Load garments in loose heaps evenly around the washplate.

Do not load garments directly over the center of the washplate.

Adding wet items to washer or adding more water to basket

could unbalance washer.

Wash smaller loads to reduce imbalance.

Use Bulky Item cycle for oversized, non-absorbent

items such as

jackets and small comforters.

Empty pockets before washing. Loose items such as coins

could fall between basket and tub or may block pump.

It may be necessary to call for service to remove items.

It is normal to hear metal items on clothing such as metal snaps,

buckles, or zippers touch against the stainless steel basket.

It is normal to hear the pump making a continuous humming sound

with periodic gurgling or surging as final amounts of water are

removed during the spin/drain cycles.

You may hear the hum of the sensing spins after you have started

the washer. This is normal. Sensing spins will take several minutes

before water is added to the washer.

Water may splash off basket if washer is not level.

Tighten fill-hose connection.

Make sure all four fill hose flat washers are properly seated.

Pull drain hose from washer cabinet and properly secure it to

drainpipe or laundry tub.

Water can back up out of a clogged sink or drainpipe. Check

all household plumbing for leaks (laundry tubs, drain pipe,

water pipes, and faucets.)

Unbalanced loading can cause basket to be out of alignment

and cause water to splash off tub. See "Using Your Washer"

for loading instructions.

This is normal operation for an HE low-water washer. The load will

not be completely under water. The washer senses load sizes and

adds correct amount of water for optimal cleaning. See "What's

New under the Lid."

IMPORTANT: Do not add more water to washer. Adding water lifts

the garments off the washplate, resulting in less effective cleaning.

Not enough water

in washer