Whirlpool 7MWTW1955EW Instrukcja obsługi i konserwacji - Strona 28

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Spryskiwacz Whirlpool 7MWTW1955EW. Whirlpool 7MWTW1955EW 33 stron. Top-loading washer

Drukuj stronę

TROUBLESHOOTING

First try the solutions suggested here or consult the warranty sheet in the washer for assistance and to possibly avoid a service call.

If you experience

Washer Not Performing As Expected (cont.)

Washer not

draining/spinning, loads

are still wet, or spin light

remains on (indicating

that the washer was

unable to pump out

water within 10 minutes)

(cont.)

Dry spots on load

after cycle

Incorrect or wrong

wash or rinse

temperatures

Load not rinsed

Sand, pet hair, lint,

etc. on load after

washing

Load is tangling

Possible causes

The washer may be tightly packed

or unbalanced.

Check plumbing for correct drain

hose installation. Drain hose extends

into standpipe further than

4.5" (114 mm).

Too much detergent causing suds to

slow or stop draining and spinning.

High speed spins extract more

moisture than your previous washer.

Added extra garments to the load

after the sensing/fill phase.

Check for proper water supply.

Energy saving controlled

wash temperatures.

Check for proper water supply.

Not using HE detergent or using too

much HE detergent.

Washer not loaded as recommended. The washer is less efficient at rinsing when load is tightly packed.

Heavy sand, pet hair, lint, and

detergent or bleach residues may

require additional rinsing.

Washer not loaded as recommended. See "Using Your Washer" section.

Tightly packed or unbalanced loads may not allow the washer

to spin correctly, leaving the load wetter than normal. Evenly

arrange the wet load for balanced spinning. Select the Drenar y

Exprimir (Drain & Spin) cycle to remove excess water. See "Using

Your Washer" for loading recommendations.

Check drain hose for proper installation. Use drain hose form

and securely attach to drain pipe or tub. Do not tape over drain

opening. Lower drain hose if the end is higher than 96" (2.4 m)

above the floor. Remove any clogs from drain hose.

Use only HE detergent. Always measure and follow detergent

directions for your load. To remove extra suds, select Drenar y

Exprimir (Drain & Spin). Do not add detergent.

The high spin speeds combined with air flow during the final spin

can cause items near the top of the load to develop dry spots

during the final spin. This is normal.

Add only one or two additional garments after washer has

started.

Make sure hot and cold inlet hoses are not reversed.

Both hoses must be attached to both washer and faucet,

and have both hot and cold water flowing to inlet valve.

Check that inlet valve screens are not clogged.

Remove any kinks in hoses.

This washer uses cooler wash and rinse water temperatures

than traditional top-load washers. This includes cooler hot and

warm washes.

Make sure hot and cold inlet hoses are not reversed.

Both hoses must be attached and have water flowing to the

inlet valve.

Both hot and cold water faucets must be on.

Inlet valve screens on washer may be clogged.

Remove any kinks in the inlet hose.

The suds from too much detergent can keep washer from

operating correctly. Always measure detergent and follow

detergent directions based on load size and soil level.

Load garments in loose heaps evenly around the basket wall.

Load with dry items only.

Use cycle designed for the fabrics being washed.

Add only one or two additional garments after washer has

started.

Use the Edredones (Bulky Items) cycle or the Llenado Profundo

(Deep Fill) option for higher water fill. See "Cycle Guide" to

match your load with the best cycle.

Add 2 Rinses to the selected cycle and/or use Edredones (Bulky

Items) cycle.

Select a cycle with a slower wash action and spin speed;

however, items will be wetter than those using a higher speed

spin. Use the Edredones (Bulky Items) cycle or the Llenado

Profundo (Deep Fill) option for higher water fill. See the "Cycle

Guide" to match your load with the best cycle.

Load garments in loose heaps evenly around the basket wall.

Solution