Whirlpool 8318507 Instrukcja instalacji - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Spryskiwacz Whirlpool 8318507. Whirlpool 8318507 10 stron. 120-volt, 60-hz washer
Drukuj stronę
E
A
B
C
D
B
A
C
E
D
A
Preparation
SLIDE WASHER ONTO CARDBOARD OR HARDBOARD
BEFORE MOVING ACROSS FLOOR.
Move washer close to its final location.
Read, then remove the label (E) that covers the power supply
cord.
Remove shipping strap (A).
Completely remove the shipping strap with 2 cotter pins (B) from
the inside of the washer.
Pull the strap completely out of the washer.
Pull firmly to remove the other end of the shipping strap (C) from
the back of the washer to release self-leveling legs (D).
Save the shipping strap to secure drain hose.
B
Inlet hose
connection
(to washer)
Use new hoses and washers that came with your washer.
Insert a flat washer (A) into each end of the inlet hoses (B).
Check that washers are firmly seated in couplings (C).
Attach hose to hot water (bottom) inlet valve (D) first; then
second hose to cold water (top) inlet valve (E). Tighten couplings
by hand. Then use pliers to make additional two thirds turn.
DO NOT OVERTIGHTEN; this could cause damage to couplings.
Inlets are plastic. DO NOT STRIP OR CROSSTHREAD.
B
D
F
F
E
C
H
G
A
C
E
(
)
A
(
)
2
B
(
)
C
(
)
D
(
)
(
B
)
C
(
)
D
(
)
E
(
)
E
E
(
A
)
5