Whirlpool ADG 3550 Skrócona instrukcja obsługi - Strona 2
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Spryskiwacz Whirlpool ADG 3550. Whirlpool ADG 3550 4 stron.
Drukuj stronę
How to use the dishwasher
1. After loading the dishwasher, close the
door properly and open the water
supply tap.
2. The dishwasher switches on
automatically as soon as the programme
selector knob is turned. One of the
programme indicator lamps will
illuminate.
3. Turn the selector knob to select the
desired programme. The
corresponding indicator lamp lights
up. If necessary. select options (if
supplied).
4. Press the Start button to start the
selected wash programme. The Start
indicator lamp will illuminate. Once
set, the programmed data cannot be
altered by pressing the programme
selector buttons.
Note: once the Start button has been
pressed, the dishwasher memorises
the last programme selected. This
information remains in the memory even
during interruption of the power supply.
To change the selected
programme, press the Start button
for about 5 seconds, until the
Start indicator lamp switches
off. Select a new programme using
the programme selector knob and
press the Start button.
Note: if the dishwasher is switched
off during a wash programme, when
switched on again the dishwasher
resumes the wash cycle from where it
was interrupted.
Only open the dishwasher door
if strictly necessary during a wash
cycle and exercise maximum caution.
Danger of scalding from steam.
5. To indicate the end of the programme,
the Start indicator lamp switches off
and the End indicator lamp (if fitted)
switches on (for about 30 min.).
6. Turn the programme selector knob to
the "0" position to switch off the
dishwasher (only after the Start
indicator lamp has switched off). All
the indicator lamps switch off.
7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.
Upper rack
Please read the user instructions carefully.
Upper and lower rack
Rack height adjustment:
(The dishwasher is delivered with the upper
rack in the top position).
The rack height can also be changed
when loaded.
•
To lower: pull out the two side
handles and gently lower the rack.
•
To raise: pull up the two side handles
until the rack clicks into place.
•
The rack must be level on both
sides.
Crockery holders:
•
Down: cups and long-stemmed
glasses.
•
Up: plates.
Glass holder:
Lower rack
A
A
C
Plate holders:
•
(A) May be lowered to increase
available space.
Cutlery basket:
The cutlery basket can be removed to
increase (C) available space.
C