Whirlpool AWE 6760 Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Whirlpool AWE 6760. Whirlpool AWE 6760 16 stron. 6kg, 1000rpm, top loader washing machine, white awe 6760

Drukuj stronę

CARE AND MAINTENANCE

Always unplug the washing machine before doing any maintenance.

Detergent dispenser

Clean the detergent dispenser regularly, at least three or

four times a year, to prevent detergent build-up:

1. Push in the buttons on each side of the dispenser.

2. Pull the dispenser towards you and remove it.

A small quantity of water can remain in the dispenser. It is

advisable to carry the dispenser in an upright position.

3. Wash the dispenser using running water.

You can also remove the siphon caps in the dispenser for cleaning.

4. Replace the siphon caps in the dispenser (if removed).

Make sure that they lock in place.

5. Replace the dispenser by locating the bottom tabs in the lid

holes and pivot until both of the upper buttons lock.

Note: ensure that the detergent dispenser is correctly

reinstalled.

Water inlet hose filter

Check and clean regularly (at least two or three times a year).

1. Unplug the washing machine.

2. Turn off the tap.

3. Unscrew the hose from the tap.

4. Carefully clean the filter located at the end of hose, without

disassembling it, for example with a tooth-brush.

Note: Do not submerge the hose in water.

5. Screw the flexible hose back onto the tap by hand. Do not use

pliers (risk of squashing the joint).

6. Turn on the tap and check that the connections are

water-tight.

7. Plug the washing machine back in.

Water inlet hose (A, B or C, depending on model)

Check the inlet hose regularly for brittleness and cracks and

replace it if necessary using a new hose of the same type.

The inlet hose as shown on picture "A" has a safety valve to

prevent the appliance against uncontrolled water inlet; if the

safety valve inspection window is red, the safety valve has been

activated and the hose must be exchanged. Contact out After-

Sales Service or your specialist dealer to obtain a new inlet hose.

For unscrewing the inlet hose as shown on picture "A", you must push

down the release lever while unscrewing it.

If your inlet hose has a transparent hose coating (fig. "B"),

periodically check the colour of the transparent coating. If the

transparent hose shows a local dark colour change, this is an

indication that the hose may have a leak and should be replaced.

Contact our After-Sales Service team or specialist dealer to

obtain a replacement hose.

GB 10

Release

lever

Safety

valve

inspection

window