Whirlpool AWM 9100 GH Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Whirlpool AWM 9100 GH. Whirlpool AWM 9100 GH 15 stron.

Connect the water supply hose

1.Carefully screw the hose connection onto the tap,

preferably by hand.

2.Make sure there are no kinks in the hose.

3.Check water-tightness of tap and appliance connections by

turning the tap completely on.

The appliance must not be connected to the mixing tap of a

non-pressurized water heater.

The appliance can be connected without a non-return valve.

Check the supply hose regularly for brittleness and cracks and

replace if necessary using a new hose of the same type

(available from After-Sales Service or specialist dealer).

If the flexible hose is damaged, unplug the appliance from

the mains immediately.

Water supply hose "A"

If the hose is too short, replace it with a suitable length of

pressure resistant hose (minimum 1000 kPa - EN 50084

approved type).

Mount the new hose professionally on the washing machine

and the tap.

Water supply hose "B"

If the hose is too short, replace it with a longer length of

"Water Stop" hose (available from After-Sales Service or

specialist dealer).

Mount the new hose professionally on the washing machine

and the tap.

Note: The inlet hose and the plastic enclosure at the water

connection contain electrical components. For this reason,

do not cut the hose and do not immerse the plastic

enclosure in water.

Connect the water drain hose

1.Connect the drain hose to the ventilated siphon or hook it over the edge of a sink with the "U" bend.

2.Make sure there are no kinks in the hose.

3.Secure the hose so that it cannot fall down while the appliance is running.

Small wash-hand basins are unsuitable.

If you need to add an extension, use a hose of the same type. Secure the connections with clips.

Max. drain hose length: 2.50 m

Max. drain height: 1.25 m

Min. drain height: 0.70 m

Home

Appliances