Whirlpool AWO D5306 Podręcznik - Strona 11

Przeglądaj online lub pobierz pdf Podręcznik dla Spryskiwacz Whirlpool AWO D5306. Whirlpool AWO D5306 14 stron.

Drukuj stronę

TROUBLESHOOTING GUIDE

Depending on the model, your washing machine is

equipped with various automatic safety functions.

This enables faults to be detected in good time and

the safety system can react appropriately. These

faults are frequently so minor that they can be

removed within a few minutes.

The washing machine will not start, no

indicator lamps are on.

Check whether:

• the mains plug is inserted into the socket;

• the wall socket is functioning correctly (use a

table lamp or similar appliance to test it).

The washing machine will not start... and the

"Start/Pause" indicator lamp flashes.

Check whether:

• the door is properly closed (child safety);

• the "Start/Pause" button has been pressed;

• the "Water tap closed" indication lights up. Open

the water tap and press the "Start/Pause" button.

The appliance stops during the programme

(varies depending on model)

Check whether:

• the "Rinse Hold" indicator lamp lights up;

terminate this option by pressing the

"Start/Pause" button or by choosing and

starting the "Drain" programme;

• another programme has been selected and the

"Start/Pause" indicator lamp is flashing.

Reselect the desired programme and press the

"Start/Pause" button.

• the door has been opened and the "Start/

Pause" indicator lamp is flashing. Close the door

and press the "Start/Pause" button again.

• the washing machine's safety system has been

activated (see "Fault description table").

Residue from detergent and additives left in

the detergent drawer at end of wash.

Check whether:

• the cover grid of the softener chamber and the

separator of the main wash chamber are

correctly installed in the detergent dispenser and

all parts are clean (see "Care And Maintenance");

• sufficient water is entering.

The mesh filters of the water supply could be

blocked (see "Care And Maintenance");

• the position of the separator in the main wash

chamber is adapted to the use of powder or

liquid detergent (see "Detergent and Additives").

Machine vibrates during spin cycle.

Check whether:

• the washing machine is level and standing firmly

on all four feet;

• the transport bolts have been removed. Before

using the machine, it is imperative that the

transport bolts are removed.

Final spin results are poor.

The washing machine has an imbalance detection

and correction system.

If individual heavy items are loaded (e.g. bathrobes),

this system may reduce the spin speed

automatically or even interrupt the spin completely

if it detects too great an imbalance even after

several spin starts, in order to protect the washing

machine.

• If the laundry is still too wet at the end of the

cycle, add smaller articles of laundry and repeat

the spin cycle.

• Excessive foam formation may prevent spinning.

Use the correct amount of detergent.

• Check that the spin speed selector has not been

set to "0".

If your washing machine has a time display:

the programme time initially displayed is

lengthened / shortened by a period of time:

This is a normal capacity of the washing machine to

adapt to factors that can have an effect on the wash

programme time, e.g.:

• excess foam formation;

• load imbalance due to heavy items of laundry;

• prolonged heating time due to reduced inlet

water temperature;

Because of influences like these, the time remaining

in the programme run is recalculated, and updated

if necessary. In addition, during the filling phase, the

washing machine determines the load and if

necessary adjusts the initial programme time

displayed accordingly. During such update periods,

an animation appears on the time display.