Whirlpool 3WSC19D4AY00 Instrukcje użytkownika - Strona 22

Przeglądaj online lub pobierz pdf Instrukcje użytkownika dla Lodówka Whirlpool 3WSC19D4AY00. Whirlpool 3WSC19D4AY00 24 stron.

ICE AND WATER

Possible Causes and/or Recommended Solutions

(on some models)

Water is leaking or

NOTE: After dispensing, a few additional drops of water are normal.

dripping from the

dispenser

Water is leaking

from the back of the

refrigerator

Water from the

NOTE: On some models, water from the dispenser is chilled to 50°F (10°C).

dispenser is

not cool enough

Glass was not held under the dispenser long enough - Hold the glass under the dispenser for

2 to 3 seconds after releasing the dispenser pad/lever.

New installation, or water filter was recently installed or replaced - Air in the water lines causes the

water dispenser to drip. Flush the water system to remove the air in the water lines. See "Water and Ice

Dispensers."

Residual ice in the dispenser chute is melting - Make sure the ice chute is free of ice shavings or

pieces.

Water line connections are not fully tightened - Make sure all connections are firmly tightened. See

"Connect Water Supply."

New installation - Allow 24 hours after installation for the water supply to cool completely.

Recently dispensed a large amount of water - Allow 24 hours for the new water supply to cool

completely.

Water has not been recently dispensed - The first glass of water may not be cool. Discard the first

glass of water dispensed.

Refrigerator is not connected to a cold water pipe - Make sure the refrigerator is connected to a cold

water pipe. See "Water Supply Requirements."