Whirlpool 4370070 Instrukcja instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Lodówka Whirlpool 4370070. Whirlpool 4370070 11 stron.

Procedure
Important
Save all screws and reuse in original location.
1. Remove top handle end caps by removing screws.
2. Remove cn~~hedkubed ice switch cover on
dispenser by pulling forward. Release bottom clips
on dispenser cover by placing taped edge of putty
knife underneath cover and pulling out. Release top
clips by holding bottom of dispenser cover out and
sliding up.
1
I
6. InstaY new top handle end caps by pladng on
handles. Insert and tighten screws.
7. Replace dispenser cover by snapping in place.
Replace switch cover by snapping in p&e.
6. Remove toe grille by pulling fomard.
Caution
To avoid personal injury or property damage,
temporarily tape doors shut.
9. Tape doors shut using masking tape.
A
WARNING
Electrical Shock Hazard
Green ground wire must remain attached to hinge.
Failure to do so can result in death or electrical shock.
10. Remove top hinge covers by removing screw%
Trscs around lop hinges with a pencil. This helps
alignment when reassembling. Unplug top hinge
I
wire connectors. Do nof remove green ground wire
mm hinge. Remove top hinge screws.
3. Remove door handle inserts by placing screwdriver
at top of door handles in area between handle and
insert and pulling out. Pull inserts out along length
of handles.
4.
Remove end caps from bottom of handles by putting
down. Install new bottom handle end caps by
placing end caps in bottom of handles and snapping
in place.
5. Install new handle inserts by placing insert on
handles and snapping in place.
wire conr#eto
wire wnnecton
L
11. Remove tape from refrigerator door. Qmsp
refrigerator door securely and lift up while opening.
This will free door from bottom hinge pin. Top hinge
nUyCOfllBOffdOOK