Ariston TCF 87B Instrukcja obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Suszarka Ariston TCF 87B. Ariston TCF 87B 17 stron.
Drukuj stronę
19510300500_AUS
Start and Programmes
TD4254FUH Issue 2
The Controls
•
Programmes knob
! Warning,
if after pressing the start button the programme
knob position is changed, the new position will NOT change
the programme selected. To change programme press
Start/Pause Button
to pause the programme, the light flashes
Amber to indicate the programme is paused. Select the new
programme and any options required, the light will then flash green.
Press the Start/Pause Button
•
Option Buttons/ Lights
These buttons are used to customise the selected programme
to your requirements. A programme must have been selected
on the Programmes knob before an option can be selected.
Not all options are available for all programmes (see Start and
Programmes). If an option is not available and you press the
button, the buzzer will beep three times. If the option is
available the light in the button is lit to confirm your selection.
After the start switch has been pressed were available only the
Sound option can be changed.
•
Progress (
Drying,
These are part of the Display unit they indicate the progress of
the dryer each one comes on as the corresponding phase
starts.
•
Time Delay
The start of some programmes (see Start and Programmes and
The Display) can be delayed for up to 24 hours. Ensure the water
bottle is emptied before setting a delayed start.
During this period the clothes are occasionally tumbled
to help prevent creases developing.
•
Extra Care
This Anti-ageing function for Cottons
maintain the brightness of your laundry for long time thanks to
the use of the right drum rotation (reduced in the last part of
cycle) and the correct drying temperature.
Note: It cannot be used with the "Extra Dry", "Cupboard Dry" and
"Light Dry" dryness levels
Sound
If selected gives a signal at the end of the drying cycle to
remind you that the clothes are ready to be removed. Not
Available on Heat & Enjoy programme.
•
Heat Level Button and Lights
Not all programmes allow you to change the heat level, and
some of these programmes do allow all three heat level
options. When the option change the heat level is available
pressing this button changes the heat level selected and the
corresponding light is lit for the three available levels, Low,
Medium and High.
DISPLAY
The display shows either the amount of time delay remaining
or an indication of the amount of time left for a drying
programme. (see The Display
and minutes display flash to show that the time is counting
down.
When the programme finishes its cool tumble phase the
display will show
.
English, All Logos to be Ariston
and the new programme will start.
Cool tumble), Icons
and Synthetics
helps to
The Colons between the hours
)
{PDF Created 18/01/13 22:28:00}
•
Empty Water Icon / Container
(If you have plumbed your dryer to a drain this light can be
ignored, as there is no need to empty the water container.)
When this icon
is on its reminds you to empty the water
container.
If the water container fills during a programme, the heater
turns off and the dryer does a period of Cool Tumble then the
buzzer sounds, the bottle full icon
shows
and the .Empty water icon
You must empty the container and restart the dryer or the
clothes will not dry. After re-starting the dryer the display will
take a few seconds to go refresh.
To avoid this always empty the water container each time you
use the dryer (see Maintenance
•
Door Opening
Opening the door (or pressing the Start/Pause Button
during a programme will stop the dryer and have the following
effects..
•
The Start/Pause Light flashes Amber.
•
During a delay phase the delay will continue to
count down. The start button must be pressed to
resume the delay programme.
•
The start button must be pressed to resume the
programme. The progress lights will change to
show the current status and the Start/Pause light
will stop flashing and turn green.
•
Changing the Programmes knob will select a new
programme and the Start/Pause Light will flash
green. You can use this to select the Refresh
programme
them dry enough.
Press the start button to begin a new Programme.
•
Note
If you have a power cut, switch off the power or
remove the plug, press and hold the
until the dryer reactivates, then press the Start/Pause
Button.
11
flashes, the display
is displayed
to cool the clothes if you find
On/Off
button
)