Cal Spas CalSalt Filtration Instrukcja obsługi - Strona 13
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Dozownik wody Cal Spas CalSalt Filtration. Cal Spas CalSalt Filtration 16 stron.
Drukuj stronęSymptom on
PowerSupply
Display
LED
1
no
no display
lights
no
"_ _"
2
lights
no
"_ _"
3
lights
4
"LO" and
Yellow
Hours by
light
default
alternating
Hours
5
Green
(05 by
light
default)
6
"HI" and
Red
Hours (05
light
by
default)
7
"HI"
Red light
blinking
8
"88" blinking
All lights
blinking
Symptom in Spa Water
9
chlorine level is too low
10
chlorine level is too high
Possible Causes
1 - power outage
2 - power supply failure
unit in rest mode
1 - chlorinator cell is
outside water
2 - open circuit in
chlorinator cell
3 - salt level low
1 - salt level low
2 - water temperature
low
3 - chlorinator cell
at its life's end
normal operations mode
1 - salt level high
2 - water temperature
high
1 - salt level too high or high
TDS Levels
2 - water temperature
too high
3 - short circuit in
chlorinator cell
Power supply failure
Hours set too low
Hours are set too high
Solution
Make sure there is power to the unit.
Need to replace the power supply.
No action is needed:
The two dashes means end of the time cycle. For
example, If the system is setup to 10 hrs, after 10hrs
the display will show the dashes. After 24hrs the unit
will come back to work again for 10 hrs. So the display
will show two dashes for 14 Hrs. in this example.
Please check the below table for your reference.
Put it back into the water.
Check the wire connections and make
sure there are no cut or broken wires.
Add more salt to spa and allow
time for it to dissolve.
Add more salt to spa and allow
time for it to dissolve.
Don't use if the water temperature
is under 15 C ° (65 F °).
Need a new cell replacement.
No action needed
No action is needed. Stop adding salt to water if
you are doing so.
Using unit for water termperature above
45 ˚ (110 F ˚ ) is not recommended
You will have to dilute your spa water with fresh water
until the salt level is less than 3000 ppm. Dead Sea Salt
can cause HI on the Mini. Also check your TDS Levels.
Stop using unit until water cools down.
Check to make sure there are no metal objects caught
in between electrode plates.
Unplug and plug in the power cord to reset the
power supply. If problem persists, call customer
service.
Adjust the hours setting to higher number (the
maximum is 24 hours/day).
Make sure cyanuric acid level in your spa is between
50 - 80 PPM.
Adjust the hours setting to lower number (the
minimum is 0 hours/day.
13