Ariston TVM63X NA Informacje o usłudze - Strona 17

Przeglądaj online lub pobierz pdf Informacje o usłudze dla Suszarka Ariston TVM63X NA. Ariston TVM63X NA 19 stron. Electro-mechanical vented tumble dryers

Drukuj stronę
Ariston TVM63X NA Informacje o usłudze
Indesit
Company
Drive Belt Fitting
1.
Slide the new belt onto the drum and replace the front panel.
2.
Place the Special Tool, Part No. C00142716 (5600266), onto the inside edge of the new belt (cut
out section of tool facing the drum).
3.
Ease the special tool onto the motor shaft as far as possible.
4.
Rotate the special tool in either direction to refit the belt onto the shaft.
P
Capacitor
1.
Remove the right hand side panel as in (F).
2.
Note the wiring connections and disconnect the leads from the capacitor terminals.
3.
Carefully lay the dryer on its back and remove the capacitor securing nut.
Q
Drum Assembly
1.
Remove the top cover as in (A)
2.
Remove the console as in (B)
3.
Remove the front panel as in (G).
4.
Remove the right hand panel to make drum removal easier.
5.
Remove the rear bearing cover - 2 screws.
6.
Remove the rear bearing fixing screw.
7.
Remove the drive pin and shaft collar.
Note: When reassembling, a new drive pin must be fitted.
8.
Remove the rear bearing.
9.
Pull the drum clear of the rear panel.
R
Heating Assembly & Thermostats
1.
Remove the right hand side panel as in (F).
2.
Disconnect the wiring to the heater assembly (multi-pin connector).
3.
Remove the bearing cover.
4.
Remove the 8 screws securing the heater assembly to the rear panel.
5.
Remove the 2 screws retaining the element and thermostats to the heater cover.
If replacing the thermostats both the cycling and one-shot thermostat MUST be replaced should
either fail.
NOTE: - When refitting the heater cover, ensure the heater wiring Is not trapped between the
inner and outer rear panels.
S
Rear Bearing
1.
Remove the plastic, fan shaped bearing cover.
2.
Remove the drive pin.
3.
Remove the bearing fixing screw.
4.
Slide the bearing off the drum shaft.
Note: To maintain the earthing of the drum, the correct bearing fixing screw MUST be used.
Service Manual UK
17 of 19
English