Whirlpool YET17JKYJW00 Instrukcja obsługi i konserwacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Lodówka Whirlpool YET17JKYJW00. Whirlpool YET17JKYJW00 36 stron. Top-mount refrigerator

Drukuj stronę

INSTALLINGYOUR

REFRIGERATOR

Depending on your model, do not remove the white

Styrofoam insert that is located behind the control panel on

the ceiling of the refrigerator. The insert is part of the

refrigerator and not part of the packing material. If the insert

is removed, ice may migrate down from the freezer and cause

icicles to form.

Excessive Weight Hazard

Use two or more people to move and install

refrigerator.

Failure to do so can result in back or other injury.

Remove

shelves from the shipping position (shelves are

shipped upside down):

IMPORTANT: Do not clean glass shelves with warm water when

they are cold. Shelves may break if exposed to sudden

temperature changes or impact, such as bumping. For your

protection, tempered glass is designed to shatter into many small

pebble-size pieces. This is normal.

NOTE: Glass shelves are heavy. Use special care when removing

them to avoid impact from dropping.

1. Grasp the front of the upper shelf with one hand and use the

other hand to remove packing material from the shelf area.

2. Lower the front of the upper shelf until shelf hooks can be

removed from the shelf supports and pull the shelf forward.

3. Flip the shelf over and insert the rear shelf hooks into the

shelf supports. Tilt the front of shelf up until rear shelf hooks

drop into the shelf supports.

4. Lower the front of the shelf and check to make sure that it is

securely in position.

Removing

packaging

materials

•

Remove tape and any labels from your refrigerator before

using (except the model and serial number label).

To remove any remaining tape or glue, rub the area briskly

with your thumb. Tape or glue residue can also be easily

removed by rubbing a small amount of liquid dish soap over

the adhesive with your fingers. Wipe with warm water and

dry.

Do not use sharp instruments,

rubbing alcohol, flammable

fluids, or abrasive cleaners to remove tape or glue. These

products can damage the surface of your refrigerator. For

more information, see "Refrigerator

Safety" section.

On some models, shelves, bins, door shelf rails, and other

feature parts may be packaged in the Interior FeaturePak.

Follow the instructions

contained in the package for proper

assembly.

IMPORTANT:

•

Depending on your model, do not remove any permanent

instruction

labels inside your refrigerator or the Tech Sheet

that is fastened behind the base grille.

When Moving Your Refrigerator:

Your refrigerator is heavy. When moving the refrigerator

for cleaning or service, be sure to protect the floor.

Always pull the refrigerator straight out when moving it.

Do not wiggle or "walk" the refrigerator when trying to move

it, as floor damage could occur.

Explosion Hazard

Keep flammable materials and vapors, such as

gasoline, away from refrigerator.

Failure to do so can result in death, explosion,

or fire.

To ensure proper ventilation for your refrigerator, allow for a

.5 in. (1.25 cm) space on each side

Allow 3 in. (7.5 cm) of space between overhead cabinets and

refrigerator top.

Allow at least 1 in. (2.5 cm) between back of cabinet and the

wall.

_11 I

2" (5.08

era)