Whirlpool YET18RKXJW00 Instrukcja obsługi i konserwacji - Strona 16
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Lodówka Whirlpool YET18RKXJW00. Whirlpool YET18RKXJW00 36 stron. Top-mount refrigerator
Drukuj stronę
Off-taste, odor or grey color in the ice
•
Are the plumbing connections
new, causing
discolored
or
off-flavored
ice?
Discard the first few batches of ice.
•
Have the ice cubes been stored for too long?
Throw old ice away and make a new supply.
•
Has food in the refrigerator
been wrapped
properly?
See the "Refrigerator
Features" section.
•
Do the freezer and ice bin need to be cleaned?
See the "Cleaning Your Refrigerator"
section.
•
Does the water contain
minerals
(such as sulfur)?
A filter may need to be installed to remove the minerals.
•
Is there a water filter installed on the refrigerator?
Grey or dark discoloration
in ice indicates that the water
filtration system needs additional flushing. Run additional
water through the water dispenser to flush the water filtration
system more thoroughly at least 2 to 3 gallons (8 to12 L) or 6
to 7 minutes initially. Discard discolored ice.
The water dispenser will not operate properly
•
Has the water system not filled?
The water system needs to be filled the first time it is used.
Use a sturdy container to depress the water dispenser bar
until the water begins to flow. Flush the water system by
dispensing and discarding 2 to 3 gallons (8 to 12 liters) of
water. Cleaning the system will take approximately
6 to 7
minutes and will help clear air from the line. Additional
flushing may be required in some households. See the "Water
Dispenser" section.
•
Is the water shut-off valve not turned on or the water line
connected
at the source?
Check to be sure the water shut-off valve is turned on and the
water source is connected to the refrigerator. See the
"Connecting
the Refrigerator to a Water Source" section for
directions.
•
Is the water shut-off valve clogged
or incorrectly
installed?
See the "Connecting
the Refrigerator to a Water Source"
section. If clogging or installation is not a problem, call for
service or contact a plumber.
•
Is there a kink in the home water source line?
If you find or suspect a kink in the water line, call for service.
•
Is there a water filter installed
on the refrigerator?
The filter may be clogged or incorrectly
installed. First, check
the filter installation instructions
to ensure that the filter was
installed correctly and is not clogged. If installation or
clogging is not a problem, call for service.
Water leaking from the dispenser
9,",'
__
•
Is the glass not being held under the water dispenser
long
enough, causing
water to drip?
Hold the container under the water dispenser two to three
seconds after releasing the dispenser lever. Water may
continue to dispense during this time.
•
Is there a water filter installed
on the refrigerator?
The water filtration system may have air in the lines, causing
water to drip. Additional flushing may help clear air from the
lines. Normal dispenser use should flush air from the lines
within 24 to 72 hours.
The dispenser water is not cool enough
•
Has the refrigerator
been newly installed?
Allow 24 hours for the refrigerator to cool completely.
•
Has a large amount of water been recently dispensed?
Allow 24 hours for the water to cool completely.
•
Has water not been recently
dispensed?
The first glass of water may not be cool. Discard the first
glass of water.
Water flow from the dispenser decreases noticeably
•
Is there a water filter installed on the refrigerator?
The filter may be full or incorrectly
installed. Depending on
your model, remove the water filter cartridge (see the "Interior
Water Filtration System" section.) Operate the dispenser. If
the water flow increases noticeably, your filter is full and
needs to be replaced.
The divider between the two compartments
is warm
The warmth is probably due to normal operation of the
automatic exterior moisture control. If still concerned, call for
service.
Temperature is too warm
•
Are the air vents blocked
in either compartment?
This
prevents the movement
of cold air from the freezer to the
refrigerator.
Remove any objects from in front of the air vents. See the
"Ensuring Proper Air Circulation" section for the location of air
vents.
Are the door(s) opened often?
Be aware that the refrigerator will warm when this occurs. In
order to keep the refrigerator cool, try to get everything you
need out of the refrigerator at once, keep food organized so it
is easy to find, and close the door as soon as the food is
removed.
•
Has a large amount of food just
been added to the
refrigerator or freezer?
Adding a large amount of food warms the refrigerator. It can
take several hours for the refrigerator to return to the normal
temperature.
•
Are the controls
set correctly
for the surrounding
conditions?
See the "Setting the Controls" section.
There is interior moisture build-up
•
Are the air vents blocked in the refrigerator?
Remove any objects from in front of the air vents. See the
"Ensuring Proper Air Circulation" section for the location of air
vents.
Are the door(s) opened often?
To avoid humidity build-up, try to get everything you need out
of the refrigerator at once, keep food organized so it is easy
to find, and close the door as soon as the food is removed.
(When the door is opened, humidity from the room air enters
the refrigerator. The more often the door is opened, the faster
humidity builds up, especially when the room itself is very
humid.)
16