Whirlpool 29" Wide Models Instrukcja instalacji - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Suszarka Whirlpool 29" Wide Models. Whirlpool 29" Wide Models 20 stron. Dryer
Również dla Whirlpool 29" Wide Models: Instrukcja instalacji (48 strony), Instrukcja instalacji (22 strony)

Drukuj stronę

Connect neutral ground wire

and neutral wire

Connect neutral ground wire (E) and neutral wire (white or

center wire) (C) of power supply cord or cable under center

terminal block screw (B). Tighten screw.

Connect remaining wires

Place hooked ends of remaining wires under outer terminal

block screws (hooks facing right). Tighten screws.

Connect external ground wire

Connect a separate copper ground wire (G) from the external

ground conductor screw (A) to an adequate ground. Finally,

reinsert tab of terminal block cover into slot of dryer rear

panel. Secure cover with hold-down screw. Now, go to

Venting Requirements.

Venting

Venting Requirements

WARNING:

To reduce the risk of fire, this dryer MUST BE

EXHAUSTED OUTDOORS.

IMPORTANT:

Observe all governing codes and ordinances.

Dryer exhaust must not be connected into any gas vent,

chimney, wall, ceiling, attic, crawlspace, or a concealed space

of a building. Only rigid or flexible metal vent shall be used for

exhausting.

4" (102 mm) heavy metal exhaust vent

Only a 4" (102 mm) heavy metal exhaust vent and clamps may

■

be used.

Do not use plastic or metal foil vent.

■

Rigid metal vent:

Recommended for best drying performance and to avoid

■

crushing and kinking.

Flexible metal vent:

clean)

Must be fully extended and supported in final dryer location.

■

Remove excess to avoid sagging and kinking that may result

■

in reduced airflow and poor performance.

Do not install in enclosed walls, ceilings, or floors.

■

The total length should not exceed 7

■

NOTE:

If using an existing vent system, clean lint from entire

length of the system and make sure exhaust hood is not plugged

with lint. Replace plastic or metal foil vents with rigid metal

or flexible metal vents. Review "Vent System Chart" and, if

necessary, modify existing vent system to achieve best drying

performance.

(102 mm)

(Acceptable only if accessible to

ft. (2.4 m).