Whirlpool 3401092 Instrukcja obsługi i konserwacji - Strona 13
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Suszarka Whirlpool 3401092. Whirlpool 3401092 25 stron. Electric and gas dryers
Drukuj stronę
Caring for Your Dryer
Proper care of your dryer can extend its life. This section explains how to care for your dryer
properly and safely.
Cleaning
the lint screen
Every
load
cleaning
The lint screen is located under a lid on top
of the dryer. Clean it before each load. A
screen blocked by lint can increase drying
time.
To clean:
1. Open the lid and pull the lint screen
straight out.
2. Roll lint off the screen with your fingers. Do
not rinse or wash screen to
remove lint. Wet lint is hard to
remove.
3. Push the lint screen firmly back into place
and close the lid.
IMPORTANT:
• Do not run the dryer with the lint screen
loose, damaged, blocked, or missing.
Doing so can cause overheating and
damage to both the dryer and fabrics.
• Some towels made of synthetic fibers and
natural fibers (polyester and cotton blends)
may shed more lint than other towels,
causing your dryer's lint screen to fill up
faster. Be sure to remove lint from the lint
screen before and after drying new towels.
As
needed
cleaning
Laundry detergents and fabric softeners can
cause a residue buildup on the lint screen.
Clean the lint screen with a nylon brush
every six months or more frequently if it
becomes clogged due to a residue buildup.
Use the following
method:
1. Wet both sides of lint screen with hot
water.
2. Wet a nylon brush with hot water and
liquid detergent; scrub lint
screen with the brush to
remove residue buildup.
3. Rinse screen with hot water.
4. Thoroughly
dry lint screen with a clean
towel; replace in dryer.
Lint signal
(on some
models)
The lint signal (a whistle tone) indicates
excessive lint is present on
your lint screen. A full lint
screen restricts airflow and
reduces drying efficiency.
When you hear the signal, stop
the dryer and clean the lint screen.
NOTE: Clean your lint screen before each
load. Do not wait for the lint signal.
13