Whirlpool 3LWED5500YW2 Instrukcja obsługi i konserwacji - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Suszarka Whirlpool 3LWED5500YW2. Whirlpool 3LWED5500YW2 48 stron.

Drukuj stronę

TROUBLESHOOTING (cont.)

First try the solutions suggested here to possibly avoid the cost of a service call.

If you experience

Cycle time too short

Lint on load

Stains on load or drum

Loads are wrinkled

Odors

Load is too hot

EU representative: Whirlpool Europe s.r.l., Viale Guido Borghi 27, 21025 Comerio (VA) Italy

Manufacturer: Whirlpool Corp., 1300 Marion-Agosta Rd., Marion, OH 43302

Possible Causes

Automatic cycle ending early.

Lint screen clogged.

Dryer fabric softener not properly

used.

Load not removed from dryer at the

end of the cycle.

Dryer overloaded.

You have recently been painting,

staining, or varnishing in the area

where your dryer is located.

The electric dryer is being used for

the first time.

Laundry items were removed from

the dryer before the end of the

cycle.

A high temperature cycle was used,

or a separate temperature control

was set on high.

The load may not be contacting the sensor strips. Level the

dryer.

Use Timed Dry for very small loads. Change the dryness level

setting on Automatic Cycles. Increasing or decreasing the

dryness level will change the amount of drying time in a cycle.

If loads are consistently ending too early, see also "Changing

the Automatic Cycle Default Settings."

Lint screen should be cleaned before each load.

Add dryer fabric softener sheets at the beginning of the cycle.

Fabric softener sheets added to a partially dried load can stain

your garments.

Drum stains are caused by dyes in clothing (usually blue jeans).

These will not transfer to other clothing.

Select Wrinkle Shield option to tumble the load without heat to

avoid wrinkling.

Dry smaller loads that can tumble freely reduce formation of

wrinkles.

If so, ventilate the area. When the odors or fumes are gone

from the area, rewash and dry the clothing.

The new electric heating element may have an odor. The odor

will be gone after the first cycle.

Allow the Cool Down step to finish before removing laundry

from dryer. All cycles are cooled slowly to reduced wrinkling

and make it easier to handle. Items removed before Cool Down

may feel very warm.

Select a lower temperature, and use an automatic drying cycle.

These cycles sense the temperature or the moisture level in the

load and shut off when the load reaches the selected dryness.

This reduces overdrying.

Solution