Whirlpool 3RAWZ481G Instrukcja instalacji - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Suszarka Whirlpool 3RAWZ481G. Whirlpool 3RAWZ481G 25 stron. Electric and gas dryer
Również dla Whirlpool 3RAWZ481G: Instrukcja obsługi i konserwacji (24 strony), Instrukcja obsługi i konserwacji (28 strony)
Drukuj stronę
IMPORTANT: Observe all governing codes
and ordinances.
Improper venting can cause moisture
and lint to collect indoors, which may
result in:
• Moisture damage to woodwork,
furniture, paint, wallpaper, carpets, etc.
• Housecleaning problems and health
problems.
Use a heavy metal vent. Do not use plastic
or metal foil vent.
Rigid metal vent is recommended to
prevent crushing and kinking.
Flexible metal vent must be fully extended
and supported when the dryer is in its final
position. Remove excess flexible metal
vent to avoid sagging and kinking that can
result in reduced airflow and poor
performance.
An exhaust hood should cap the vent to
prevent rodents and insects from entering
the home.
Exhaust hood must be at least 30.5 cm (12
in.) from the ground or any object that is in
the path of the exhaust (such as flowers,
rocks or bushes, etc.).
If using an existing vent system, clean lint
from the entire length of the system and
make sure exhaust hood is not plugged
with lint. Replace any plastic or metal foil
vent with rigid metal or flexible metal vent.
Plan vent system
Typical exhaust installations
Typical installations vent the dryer from the
rear.
Other installations are possible.
clamp
elbow
dryer
exhaust outlet
Optional exhaust installations
This dryer can be converted to exhaust out
the right side, left side, or through the
bottom.
Cover unused exhaust holes with
one of the following kits:
279818 (white)
279969 (pewter)
Contact your local dealer.
Failure to follow these instructions
can result in death, fire, electrical
shock, or serious injury.
standard rear
exhaust
wall
exhaust
hood
rigid metal or
flexible metal vent
WARNING
Fire Hazard
left or right
side exhaust
bottom exhaust (not
an option with
pedestal
installations)
Alternate installations for close clearances
over-the-top
installation
(also available with
one offset elbow)
Venting systems come in many varieties.
Select the best type for your installation.
Two close-clearance installations are
shown. Refer to the manufacturer's
instructions.
NOTE: The following kits for close
clearance alternate installations are
available for purchase. Please see the
"Assistance or Service" section of this
manual to order.
• Over-The-Top Installation:
Part Number 4396028
• Periscope Installation (For use with dryer
vent to wall vent mismatch):
Part Number 4396037 – 0 cm to 45.72
cm (0 in. to 18 in.) mismatch
Part Number 4396011 – 45.72 cm to
73.66 cm (18 in. to 29 in.) mismatch
Part Number 4396014 – 73.66 cm to
127 cm (29 in. to 50 in.) mismatch
periscope
installation
7