Whirlpool 8280525 Instrukcja obsługi i konserwacji - Strona 15
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Suszarka Whirlpool 8280525. Whirlpool 8280525 24 stron. 27" electric and gas dryers
Drukuj stronę
C
ARING FOR
C
LEANING THE LINT SCREEN
Every load cleaning
The lint screen is located in the door opening.
Clean it before starting each load. A screen
blocked by lint can increase drying time.
To clean:
1.
Pull the lint screen straight up.
2.
Roll lint off the screen with your fingers. Do not
3.
Push the lint screen firmly back into place and
close the door.
IMPORTANT:
•
Do not run the dryer with the lint screen loose,
damaged, blocked, or missing. Doing so can
cause overheating and damage to both the dryer
and fabrics.
•
Some towels made of synthetic fibers and
natural fibers (polyester and cotton blends) may
shed more lint than other towels, causing your
dryer's lint screen to fill up faster. Be sure to
remove lint from the lint screen before and after
drying new towels.
•
If lint falls of the screen during removal and into
the dryer, check the exhaust hood and remove
the lint (see "Checking Your Vent").
Y
D
OUR
RYER
rinse or wash screen to
remove lint. Wet lint is
hard to remove.
As needed cleaning
Laundry detergents and fabric softeners can cause
a residue buildup on the lint screen. This buildup
can cause longer drying times for your clothes, or
cause the dryer to stop before your load is com-
pletely dry. You may be able to see this buildup,
or the lint may be falling off the screen because it
is clogged.
Clean the lint screen with a nylon brush every six
months or more frequently if it becomes clogged
due to a residue buildup.
Use the following method:
1.
Wet both sides of lint screen with hot water.
2.
Wet a nylon brush with hot water and liquid
3.
Rinse screen with hot water.
4.
Thoroughly dry lint screen with a clean towel;
replace in dryer.
detergent; scrub lint
screen with the brush
to remove residue
buildup.
15