Whirlpool BYCCD3421W0 Instrukcja obsługi i konserwacji - Strona 17

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Suszarka Whirlpool BYCCD3421W0. Whirlpool BYCCD3421W0 20 stron. Compact electric dryer

Drukuj stronę

PROBLEM

CHECK IF

CAUSES/SOLUTIONS

shrlnklng

Items are overdried

Remove items while there is still a trace

of moisture. Some items should be

removed while damp, then shaped and

alr dried.

Fabric type and quality is

suitable for drying

Some knits are stretched during manufac-

turfng. Washing and drying returns them

to the original size. This is normal. Check

quality of garment before buying. Follow

fabric care label directions carefully.

Slow drying

There is a large amount of

moisture in the load to be

dried

Some items hold more moisture than

others (cottons more than polyester).

They take longer to dry. Full loads take

longer to dry than small loads of the same

fabric.

Cofd rinse water is used

A load rinsed in cofd water will take

slightly longer to dry than a warm one.

Cold rinses, however, help save energy

and reduce wrinkling more than warm

rinses do.

Room air temperature is

below 45°F (7°C)

Install dryer in a room where the air

temperature is warmer than 45°F (7°C).

Cold air increases drying time and may

cause wrinkles not to be removed.

Dryer is exhausted according

to Installation Instructions

Lint screen is full

Install and exhaust your dryer according

to the Installation Instructions provided.

Clean lint screen before or after

each use.

Exhaust duct or outside

exhaust hood is clogged

Proper electrical supply is

used

Clean if needed.

Properly connect the dryer to a grounded

electrical circuit that meets the electrical

requirements stated in the Installation

Instructions.

Statk

ctrklty

Load is overdrfed

Remove items while there is still a trace

of moisture.

Fabric softener is used

Use a fabric softener and follow package

directions carefully.

Synthetics, synthetic blends,

Synthetics, synthetic blends, permanent

permanent press and knits are

press and knits build up static electricity.

in load

Use a fabrii softener and be careful not

to overdry the load.