Whirlpool Cabrio,- WED7300X Instrukcja obsługi i konserwacji - Strona 13

Drukuj stronę

Whirlpool Cabrio,- WED7300X Instrukcja obsługi i konserwacji

TROUBLESHOOTING

First try the solutions suggested here or visit our website at www.whirlpool.com/help

If you experience

Vibration or Off-Balance

Vibration, rocking, or

"walking"

Vibration during spinning

or washer stopped with

all dial lights flashing

Noises

Clicking or metallic

noises

Gurgling or humming

Water Leaks

Check the following for

proper installation:

Washer not performing as expected

Not enough water

in washer

for assistance and to possibly avoid a service call.

Possible Causes

Feet may not be in contact with the

floor and locked.

Washer may not be level.

Load could be unbalanced

or too large.

Objects caught in washer

drain system.

Washer may be

draining water.

Washer not level.

Fill hoses not attached tightly.

Fill hose washers

Drain hose connection

Check household plumbing for leaks

or clogged sink or drain

Washer not loaded as

recommended.

Load not completely covered

in water.

Front and rear feet must be in firm contact with floor, and washer

must be level to operate properly. Jam nuts must be tight

against the bottom of the cabinet.

Check floor for flexing or sagging. If flooring is uneven, a 3/4"

(19 mm) piece of plywood under your washer will reduce sound.

See "Level the Washer" in Installation Instructions.

Load dry items in loose heaps evenly around basket wall.

Adding wet items to washer or adding more water to basket

could unbalance washer.

Do not overload. Do not fill above the stainless steel portion

of basket. Avoid washing single items. Balance a single item

such as a rug or jeans jacket with a few extra items. If the dial is

flashing, redistribute the load, close the lid, and press START.

Use Bulky Item cycle for oversized, non-absorbent items

such as comforters or poly-filled jackets. Other items are

not appropriate for Bulky Items cycle. See "Cycle Guide".

Item or load not suitable for selected cycle. See "Cycle Guide"

and "Using Your Washer" in this Use and Care Guide.

Empty pockets before washing. Loose items such as coins

could fall between basket and tub or may block pump.

It may be necessary to call for service to remove items.

It is normal to hear metal items on clothing such as metal snaps,

buckles, or zippers touch against the stainless steel basket.

It is normal to hear the pump making a continuous humming sound

with periodic gurgling or surging as final amounts of water are

removed during the spin/drain cycles.

Water may splash off basket if washer is not level.

Check that load is not unbalanced or overloaded.

Tighten fill-hose connection.

Are all four fill hose flat washers properly seated?

Pull drain hose from washer cabinet and properly secure it to

drainpipe or laundry tub.

Do not place tape over drain opening.

Water can backup out of a clogged sink or drainpipe. Check all

household plumbing for leaks (laundry tubs, drain pipe, water

pipes, and faucets.)

Overloading can cause basket to be out of alignment

and cause water to splash off tub. See "Using Your Washer"

for loading instructions.

This is normal operation for an HE low-water washer. The load will

not be completely underwater. The washer senses load sizes and

adds correct amount of water for optimal cleaning. See "What's

New under the Lid."

IMPORTANT: Do not add more water to washer. The added water

lifts the load off the impeller, resulting in less cleaning.

Solution