Whirlpool Cabrio,- WED7300X Instrukcja obsługi i konserwacji - Strona 10

4. Check the levelness of the washer by first placing a level on

the lid near the console. Next, place the level on the side of

the washer in the crease between the top of the washer and

the cabinet.

Level the front.

Level the side.

5. If the washer is not level, move the washer out slightly, tip

back, prop up the front of the washer on a wood block.

Adjust the feet up or down as necessary by twisting the feet.

Repeat steps 1 through 4 until washer is level.

6. Use a / " or 14 mm open-end wrench to turn the locknut

counterclockwise on the foot tightly against the washer

cabinet.

IMPORTANT: If the locknut is not tight against the washer

cabinet, the washer may vibrate.

Complete Installation

1. Check the electrical requirements. Be sure that you have the

correct electrical supply and the recommended grounding

method. See "Electrical Requirements."

2. Check that all parts are now installed. If there is an extra part,

go back through the steps to see which step was skipped.

3. Check that you have all of your tools.

4. Keep the foam packing ring from the washer tub in case you

need to move the washer in the future. Dispose of/recycle all

packaging materials.

5. Check that the water faucets are on.

6. Check for leaks around faucets and inlet hoses.

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

7. Plug into a grounded 3 prong outlet.

8. Remove any protective film or tape remaining on the washer.

9. Read "Washer Use."

10. To test and to clean your washer, measure

manufacturer's recommended amount of powdered or liquid

detergent for a medium-size load and pour it into the

detergent dispenser. Close the lid. Press POWER. Select a

normal cycle and press Start. Allow it to complete one whole

cycle.

of the detergent