Whirlpool Cabrio,- WED7300X Instrukcja obsługi i konserwacji - Strona 16

Drukuj stronę

Whirlpool Cabrio,- WED7300X Instrukcja obsługi i konserwacji

Troubleshooting

First try the solutions suggested here or visit our website at www.whirtpool.com/product

hetp -

In Canada www.whirlpool.ca

for assistance and to possibly avoid a service call.

If you experience

Washer won't run or fill,

Check for proper water supply.

washer stops working

Both hoses must be attached and have water flowing to inlet valve.

Both hot and cold water faucets must be turned on.

Check that inlet valve screens have not become clogged.

Check for any kinks in inlet hoses, which can restrict water flow.

Electrical

Shock Hazard

Plug into a grounded

3 prong outlet,

Do not remove ground prong,

Do not use an adapter.

Do not use an extension

cord,

Failure to follow these instructions can result in death,

fire, or electrical

shock.

Washer won't run or fill,

washer stops working

(cont.)

Washer not draining/

spinning, loads are still

wet

Check proper electrical supply.

Normal washer operation.

Washer may be tightly packed.

Not using HE detergent or using too

much HE detergent.

Small items may have been caught

in pump or between basket and tub,

which can stow draining.

Using cycles with a lower spin speed.

Washer may be tightly packed or

unbalanced.

Plug power cord into a grounded 3-prong outlet.

Do not use an extension cord.

Ensure there is power to outlet.

Reset a tripped circuit breaker. Replace any blown fuses.

NOTE: if problems continue, contact an electrician.

Lid must be closed for washer to run.

Washer will pause during certain phases of cycle. Do not

interrupt cycle.

Washer may be stopped to reduce suds.

Remove several items, rearrange load evenly around the

washplate. Close lid, touch and hold START/PAUSE

button.

Add only 1 or 2 additional items after washer has started.

Do not add more water to the washer.

Only use HE detergent. Suds from regular detergents can stow

or stop the washer. Always measure detergent and following

detergent directions based on your load requirements.

To remove suds, cancel cycle. Select RINSE & SPIN. Select your

cycle. Touch and hold START/PAUSE. Do not add more detergent.

Empty pockets and use garment bags for small items.

Cycles with lower spin speeds remove less water than cycles

with high spin speeds. Use the recommended

cycle/speed

spin

for your item.

Tightly packed loads may not allow the washer to spin correctly,

leaving the load wetter than normal. Evenly arrange the wet load

for balanced spinning. Select RINSE & SPiN to remove excess

water. See "Using Your Washer" for loading recommendations.