Whirlpool WGD9371YW Instrukcja instalacji - Strona 16
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Suszarka Whirlpool WGD9371YW. Whirlpool WGD9371YW 36 stron. Installation guide
Również dla Whirlpool WGD9371YW: Podręcznik użytkownika (32 strony), Instrukcja obsługi (8 strony), Instrukcja obsługi i konserwacji (40 strony)
Drukuj stronę
LEVEL DRYER
1.
Level dryer
Place
level here
Check levelness of dryer from
side to side. Repeat from front to back.
NOTE: The dryer must be level for the moisture sensing system
to operate correctly
Not Level
2.
Adjust leveling legs
If dryer is not level, prop up using a wood block, use wrench
to adjust legs up or down, and check again for levelness.
Once dryer is level, make sure all four legs are snug against
the floor and the dryer does not rock.
16
LEVEL
Not Level
COMPLETE INSTALLATION
CHECKLIST
❑
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
❑
Check that you have all of your tools.
❑
Dispose of/recycle all packaging materials.
❑
Check dryer's final location. Be sure vent is not crushed
or kinked.
❑
Check that dryer is level. See "Level Dryer".
❑
Remove film on console and any tape remaining on dryer.
❑
Wipe dryer drum interior thoroughly with a damp cloth to
remove any dust.
❑
Read "Dryer Use" in your Use and Care Guide.
Steam Models Only:
❑
Be sure the water faucets are on (steam models only).
❑
Check for leaks around "Y" connector, faucet, and hoses.
❑
If you live in a hard water area, use of a water softener is
recommended to control the buildup of scale through the
water system in the dryer. Over time, the buildup of lime
scale may clog different parts of the water system, which will
reduce product performance. Excessive scale buildup may
lead to the need for certain part replacement or repair.
Electric Models
❑
Plug into a grounded outlet.
Gas Models
❑
Plug into a grounded outlet.
❑
Check that gas supply is on.
❑
Check for leaks.
❑
Check to be sure that the flexible gas line is not crushed
or kinked.
All Models:
❑
Select a Timed Dry heated cycle, and start dryer. Do not
select Air Only Temperature setting.
If dryer will not start, check the following:
connected.
not tripped.
This dryer automatically runs an installation diagnostic routine
at the start of its first cycle.
NOTE:
You may notice an odor when dryer is first heated. This
odor is common when heating element is first used. The odor will
go away.