Whirlpool WGD94HEXW1 Instrukcja obsługi i konserwacji - Strona 16
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Suszarka Whirlpool WGD94HEXW1. Whirlpool WGD94HEXW1 40 stron. Electronic dryer
Drukuj stronę
f
First try the solutions suggested here or visit our website at www.whirlpool.com/help
-_
for assistance and to possibly avoid a service call.
Clothes are not drying
The load is too large and heavy
Separate the load to tumble freely.
satisfactorily
or drying
to dry quickly.
times are too long
Fabric softener sheets are blocking
The air outlet grille is just inside the door, behind the lint screen.
the grille.
Check that it is not blocked by a fabric softener sheet.
Use only one fabric softener sheet, and use it only once.
The dryer is located in a room with
Proper operation of dryer cycles requires temperatures
above
temperature
below 45°F (7°C).
45°F (7°C).
The dryer is located in a closet.
Closet doors must have ventilation openings at the top
and bottom of the door. The front of the dryer requires
a minimum of 1" (25 mm) of airspace, and, for most
installations, the rear of the dryer requires 5" (127 mm).
See the hstallation
hstructions.
Cycle time is too short
The load may not be contacting
Level the dryer. See the hstallation
hstructions.
All four dryer
the sensor strips on Auto Cycles.
feet should be in firm contact with the floor.
Clothes are coming out of the
Refresh cycle with damp or wet
spots.
The automatic cycle is ending
early.
Under certain environmental
or installation conditions you
may experience underdrying.
Select the Touch Up cycle
(22 min. default time), which can be customized
by selecting
High temperature.
The cycle time will automatically
be
calculated
based on the size of your load.
Change the dryness level setting on Automatic Cycles.
hcreasing or decreasing the dryness level will change the
amount of drying time in a cycle. Hfloads are consistently
ending too early, see also "Changing the Auto Cycle settings to
increase drying time".
Lint on load
Lint screen is clogged with lint.
Clean lint screen before each load.
Stains on load
Hmproper use of fabric softener.
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can
stain your garments. Do not use fabric softener sheets with
steam cycles.
Stains on drum
Loose dyes in clothes.
Drum stains are caused by dyes in clothing (usually blue
jeans). These will not transfer to other clothing.
Loads are wrinkled
The load was not removed from
dryer at the end of the cycle.
The dryer was overloaded.
For steam cycles, the water is not
properly connected with the dryer.
Select Enhanced Touch Up Cycle to tumble the load with
water and heat. This cycle is best for smoothing out wrinkles
and reducing odors from loads consisting of wrinkle-free
cotton, cotton polyester blends, common knits and synthetic
garments.
NOTE: Refer to garment care label instructions. Dry clean only
garments are not recommended.
Dry smaller loads that can tumble freely. When using the
Quick Refresh cycle, select the correct number of garments
(1-9). Results may also vary depending
on fabric type. This
cycle is best for reducing wrinkles and odors from loads
consisting of wrinkle-free cotton, cotton polyester blends,
common knits and synthetics.
Make sure water is connected to the dryer. Check that water
inlet hose is connected to both the faucet and dryer's water
inlet valve. Check that the water supply is turned on.
,J
16