Whirlpool YLEW0050PQ0 Instrukcja obsługi i konserwacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Suszarka Whirlpool YLEW0050PQ0. Whirlpool YLEW0050PQ0 32 stron. 240.volt electric dryer

Drukuj stronę
Installation
Clearances
The location must be large enough to allow the dryer door to
open fully.
Dryer Dimensions
(se.1 _ )
*Most installations require a minimum 51/2 '' (14.0 cm) clearance
behind the dryer for the exhaust vent with elbows. See "Venting
Requirements."
Installation
spacing for recessed
area and closet
installations
The following spacing dimensions shown are recommended
when the dryer is to be operated with, or without, the Stack Kit.
This dryer has been tested for installation with spacing of
0" (0 cm) clearance; however, spacing of 1" (2.5 cm) clearance is
recommended.
Recommended
spacing should be considered for
the following reasons:
•
Additional spacing should be considered for ease of
installation and servicing.
•
Additional spacing should be considered on all sides of the
dryer to reduce noise transfer.
For closet installation with a door, minimum ventilation
openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation opening are
acceptable.
•
Companion appliance spacing should also be considered.
To purchase a Stack Kit, see "Assistance
or Service."
Custom
undercounter
installation
- Dryer only
0 _j
}_
c0cm t' "'l
" '
331/4" r ain.
I
I
(
fl
I
I
I
0" _
23%"_1_-
0"
(0 cm}
_
(59.37
cm)
i
(0 cm)
C35.6 c r i)
-L
18"(45.7cm)
1-11_
'
'
Recessed
or closet installation
- Dryer only
___
i(7.5 cm)
t
1°
24 in.2"-_
_'
(155 crn2) I
3"
(7.6 cm)
0"--_1_-
--_1_- 0"
--
-_-
.'-_,, I_-"
__1(2._ cm)
(o cm)
(o cm)
A
B
C
A. Side view - closet or confined area
B. Recessed area
C. Closet door with vents
m
12"
(30.5 cm)
T--
v
o
Recessed
or closet installation
- Stacked
with stack kit
(Accessory)
._
3" C7.6 cm)
'-"_"1
I_.-
--' 3"
(7.6 cm)
48in?'_
_
t
(310 cm 2)
DRYER
WASHER
24 in.2"_
_f
3"
v
[155 crn 2)
C7.6 cm)
--_ l<-_i<-
->I I<'-
--
0" (0 cm)
0" C 0 cm)
1" C2.5 cm)
A
B
C
A. Recessed area
B. Side view - closet or confined area
C. Closet door with vents
Mobile Home - Additional
Location Requirements
This dryer is suitable for mobile home installations.
The installation must conform to the Manufactured
Home
Construction
and Safety Standard CAN/CSA-Z240
MH.
Mobile home installations require:
•
Metal exhaust system hardware, which is available for
purchase from your dealer.
Special provisions must be made in mobile homes to
introduce outside air into the dryer. The opening (such as a
nearby window) should be at least twice as large as the dryer
exhaust opening.