Whirlpool YWED85HEFW2 Instrukcja instalacji - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Suszarka Whirlpool YWED85HEFW2. Whirlpool YWED85HEFW2 48 stron.

CONNECT INLET HOSE

(STEAM MODEL ONLY)

For non-steam models, skip to "Connect Vent."

The dryer must be connected to the cold water faucet using

the new inlet hoses (not supplied). Do not use old hoses.

NOTE: Replace inlet hoses after 5 years of use to reduce the

risk of hose failure. Record hose installation or replacement

dates on the hoses for future reference.

Periodically inspect and replace hoses if bulges, kinks, cuts,

wear, or leaks are found.

Turn cold water off, remove hose,

and replace rubber washer

Turn cold water faucet off and remove washer inlet hose.

Remove old rubber washer from inlet hose and replace with

new rubber washer.

Attach short hose and "Y" connector

Attach 2 ft. (0.6 m) inlet hose to cold water faucet. Screw on

coupling by hand until it is seated on faucet. Then attach "Y"

connector to male end of the 2 ft. (0.6 m) inlet hose. Screw

on coupling by hand until it is seated on connector.

Tighten couplings

Using pliers, tighten the couplings with additional 2/3 turn.

NOTE: Do not overtighten. Damage to the coupling can result.

Attach long hose to "Y"

connector and tighten couplings

Attach one of the 5 ft. (1.5 m) inlet hose ends to the "Y"

connector. Attach washer cold inlet hose to other side of

"Y" connector. Screw on coupling by hand until it is seated

on connector. Using pliers, tighten the couplings an additional

2/3 turn.

NOTE: Do not overtighten. Damage to the coupling can result.