Whirlpool YWED92HEFBD2 Instrukcja instalacji - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Suszarka Whirlpool YWED92HEFBD2. Whirlpool YWED92HEFBD2 48 stron.

Attach long hose to dryer fi ll valve

and tighten coupling

Remove protective cap from

water inlet valve. Attach other end

of long hose to fi ll valve at bottom of dryer

back panel. Screw on coupling by hand until it is seated

on fi ll valve connector. Using pliers, tighten the couplings

an additional 2/3 turn.

NOTE: Do not overtighten. Damage to the coupling

can result.

Turn on cold water faucet

Check that the water faucets are turned on.

Check for leaks

Check for leaks around "Y" connector, faucet, and hoses.

CONNECT VENT

Connect vent to exhaust outlet

Using a 4" (102 mm) clamp, connect vent to exhaust outlet

in dryer. If connecting to existing vent, make sure vent is

clean. Dryer vent must fi t over dryer exhaust outlet and inside

exhaust hood. Check that vent is secured to exhaust hood

with a 4" (102 mm) clamp.

Move dryer to fi nal location

Move dryer to fi nal location, taking care not to crush or

kink vent or fl exible gas line.

After dryer is in place, remove corner posts and cardboard

from under dryer.