Whirlpool YWED9500E Instrukcja instalacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Suszarka Whirlpool YWED9500E. Whirlpool YWED9500E 26 stron. Gas and electric dryer

MAKE ELECTRICAL CONNECTION -

U.S.A. ONLY (EFFECTUER LE

RACCORDEMENT ÉLECTRIQUE –

ÉTATS-UNIS SEULEMENT)

Power Supply Cord

Electrical Connection Options

Choose electrical connection type

Power supply cord 4-wire receptacle

(NEMA Type 14-30R):

Go to Power Supply Cord Connection.

Power supply cord 3-wire receptacle

(NEMA Type 10-30R):

Go to Power Supply Cord Connection.

4-wire direct connection:

Go to Direct Wire Connection.

3-wire direct connection:

Go to Direct Wire Connection.

NOTE:

If local codes do not permit connection of a

cabinet-ground conductor to neutral wire, go to "Optional

3-wire connection." This connection may be used with

either a power supply cord or a direct wire connection.

Remove terminal block cover

Remove hold-down screw and terminal block cover.

Power Supply Cord Strain Relief

Attach power supply cord

strain relief

Remove the screws from a 3/4" (19 mm) UL listed strain relief

(UL marking on strain relief). Put the tabs of the two clamp

sections (C) into the hole below the terminal block opening

(B) so that one tab is pointing up (A) and the other is pointing

down (D), and hold in place. Tighten strain relief screws just

enough to hold the two clamp sections (C) together.

Attach power supply cord

to strain relief

Put power supply cord through the strain relief. Be sure that

the wire insulation on the power supply cord is inside the

strain relief. The strain relief should have a tight fit with the

dryer cabinet and be in a horizontal position. Do not further

tighten strain relief screws at this point.