Calandra Racing Concepts Carpet Knife Generation X 10 Instrukcja montażu - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Zmotoryzowany samochód zabawka Calandra Racing Concepts Carpet Knife Generation X 10. Calandra Racing Concepts Carpet Knife Generation X 10 19 stron.

Drukuj stronę
Rear X-Pod
Bag 3
17
Graphite
Top Plate
1 - Install the black 2-56 ballstuds [16] into the graphite top plate [17]. These steel balls thread into the graphite, no nut is needed. Be sure to start them
straight and square.
2 - Insert a red button head screw [22] through the bottom of the graphite top plate [17] so that the threads point upward. Slide two washers [8] over the
screw and then tighten with the red female ballstud [18].
3 - Install the Graphite X-brace [19] to the back of the two aluminum pods [20 & 21]. Use 4 red button head screws [22] to attach the graphite piece to the
aluminum.
4 - Attach the assembled top plate to the pod plates using 2 red button head screws [22].
18
8
17
Red Aluminum
2-56 Steel
Female Ballstud
Ballstud - Black
16
18
Graphite X-brace
19
22
4-40 x 1/4"
Red Button Head
22
Motor Plate
20
22
20
16
4-40 x 1/4"
Red Alum FH
8
23
Left Side Pod Plate
21
19
21
Washer
3