Calandra Racing Concepts Carpet Knife Generation X Series Instrukcja montażu - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Zmotoryzowany samochód zabawka Calandra Racing Concepts Carpet Knife Generation X Series. Calandra Racing Concepts Carpet Knife Generation X Series 18 stron.

Drukuj stronę

1 - Mount the completed tweak brace assembly to the chassis as shown using the 4-40

x 1/4" flat head screws [22]. Do this for both left and right side tweak plates.

Damper Tubes

Bag 5

1 - Use the small allen key [29] to drive the 2-56 set screw stud [30] into the thin plastic ball cup [31].

2 - Leave about 3/16" (half the set screw length) protruding from the ball cup.

3 - Do the same for the short 4-40 ballcup [32]. Use the 4-40 x 5/16" set screw [36] and the slighty larger .050" allen key. Leave about 1/8" protruding.

4 - Thread the 2 ball cups into their respective tube halves per the diagram. Finger tighten.

** Adding the Damper Tubes to the Chassis assembly **

Snap the assembled & lubed damper tubes on the respective points as

shown in the diagram to the right. You will find it easier to snap on the

centered, smaller 2-56 ball studs first, then pop the outer, larger 4-40 ballcups

2-56 set-

4-40 x 5/16"

screw stud

set screw

Delrin Plunger

.188 "

Completed Tube

2-56 Plastic

Ball Cup

Aluminum Tube

.125 "

5 - Add CRC Tube Lube [35] to each slot on the delrin plunger [33].

Build the tube and be sure it has smooth, damped action.

***

Note

: fill only the slots, not the entire aluminum tube [34]. ***

Short 4-40 Plastic

Ball Cup (on tree)

.035"

Allen Driver