CALB SE180 Instrukcja obsługi produktu - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi produktu dla Akcesoria do kamer CALB SE180. CALB SE180 10 stron.
Również dla CALB SE180: Instrukcja obsługi produktu (7 strony)

Drukuj stronę

Product User Manual

Installation for the battery pack can be followed as five steps.

The first step: Arrange the single batteries equipped with protection components and fastening

clamps in alignment (take 3 batteries for example); with fastening clamps laid at both ends of the

battery pack. As shown in figure 7.

Fastening clamp

Figure 7

Step 2: Select screws of appropriate length to run through mounting holes of fasten clamps and

single battery protectors, as shown in figure 8.

Step 3: Install nuts (including flat and spring washers) as figure 9.

Flat washer

Spring washer

Screw

(a)

Screw

Figure 8

Screw

(b)

Figure 9

Step 4: Install the bus bar. Assemble the bus bars according to grouping way, as figure 10.

Bus bar

Step 5: Install the pole protectors as shown in figure 11.

Pole protectors

The completion of battery packs' protector installation is shown above.

3. Attentions

Before installing, do check and make sure the protectors no cracks, no scratches, and no deformation;

Make sure not to scratch the battery surface and make sure battery placement accordance with electrical drawings during installation;

Make sure that the mounting holes are aligned when integrating the packs; otherwise it will affect the screw installation, causing

protectors' scratch;

Install the pole protectors promptly after connecting the bus bars, and prevent cascading battery packs from short circuit caused by

foreign objects;

The integrated packs should be placed on a workbench with flat and dry surface.

Figure 10

Figure 11