Whirlpool 30" AND 36" (76.2 AND 91.4 CM) WALL-MOUNTCANOPY RANGE HOOD Instrukcje instalacji oraz instrukcja obsługi i konserwacji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcje instalacji oraz instrukcja obsługi i konserwacji dla Okap wentylacyjny Whirlpool 30" AND 36" (76.2 AND 91.4 CM) WALL-MOUNTCANOPY RANGE HOOD. Whirlpool 30" AND 36" (76.2 AND 91.4 CM) WALL-MOUNTCANOPY RANGE HOOD 28 stron. 30" and 36" (76.2 and 91.4 cm) wall-mount canopy range hood
Również dla Whirlpool 30" AND 36" (76.2 AND 91.4 CM) WALL-MOUNTCANOPY RANGE HOOD: Instrukcja instalacji (28 strony)

Drukuj stronę

8. Tighten strain relief screw.

9. Install terminal box cover.

10. Check that all light bulbs are secure in their sockets.

11. Reconnect power.

Install Vent Covers

When using both upper and lower vent covers, push lower

cover down onto hood and lift upper cover to ceiling and install

with (2) 4.2 x 8 mm screws.

NOTE: For vented installations, the upper vent cover may

be reversed to hide slots.

A. Bracket

B. 4.2 x 8 mm screws

C. Vent cover

Secure the bottom of the duct with (2) 4.2 x 8 mm screws.

Complete Installation

1. For non-vented (recirculating) installations only, install

charcoal filters over metal grease filter. See the "Range Hood

Care" section.

2. Install metal filters. See the "Range Hood Care" section.

3. Check the operation of the range hood blower and light.

See the "Range Hood Use" section.

NOTE: To get the most efficient use from your new range

hood, read the "Range Hood Use" section.

RANGE HOOD USE

The range hood is designed to remove smoke, cooking vapors

and odors from the cooktop area. For best results, start the hood

before cooking and allow it to operate several minutes after the

cooking is complete to clear all smoke and odors from the

kitchen.

The hood controls are located on the front side of the canopy.

A. Duct cover holes

B. Duct cover

C. Control panel

D. Glass canopy

E. Grease filter

Operating the Light

The On/Off Light button controls both lights. Press once for On

and again for Off.

Operating the Blower

The Blower Speed buttons turn the blower On and control the

blower speed and sound level for quiet operation. The speed can

be changed anytime during fan operation by pressing the desired

Blower Speed button.

The Blower Off button turns the blower Off.

F. Lamp cover

G. Incandescent lamp (position

and number of lamps may vary)

H. Grease filter release handle

Range Hood Controls

A. On/Off light button

B. Blower off button

C. Blower speed minimum button

D. Blower speed medium button

E. Blower speed maximum button