FirePro FPC-2 Skrócona instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Kontroler FirePro FPC-2. FirePro FPC-2 2 stron. Fire control panel system isolation
Również dla FirePro FPC-2: Instrukcja obsługi i konserwacji (7 strony), Instrukcja obsługi i instalacji (14 strony), Instrukcja obsługi i konserwacji (8 strony)

Fire Control Panel – FP-C2

SYSTEM ISOLATION

Rev 1.0

2. Isolation using the Control Panel

Operating the Isolate key-switch by turning the key from 'Live' to 'Off' isolates the extinguishant outputs thereby

preventing discharge. This mode should only be used for service, maintenance, or temporary purposes. When in

the 'Off' position a fault will be created – the fault LED and the internal busser will operate.

With the Isolate key-switch in the 'Off' position and where the detection circuit is activated, the volt free contact

will continue to operate. The Reset and Buzzer Silence buttons will continue to be operational, when pressed.

FP-C2 Panel

Live

Off

Switch must be returned to 'Live'

3. Isolation by Unplugging the FirePro Units

All FirePro Aerosol Generators are fitted with a Deutsch Plug. Unplugging the unit it will remove it from the System.

Ensure that all units are unplugged in the system as remaining units WILL BE operational.

This will create a fault and operate internal busser in panel. The fault will be communicated to any connected

devices.

fp_c2_isol_1.0.docx

Page 2 of 2