Whirlpool AKR 9222 Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Okap wentylacyjny Whirlpool AKR 9222. Whirlpool AKR 9222 15 stron. Curved glass hood

Ducted mode air exhaust system

The hood draws the cooking fumes saturated with fumes and odor through

the grease filters and expels it to the outside through an outlet pipe.

Caution: To reduce the risk of fire, use metal

ductwork only.

1. Decide where the ductwork will run

between the hood and the outside.

2. A straight, short duct run will allow the

hood to perform most efficiently.

3. Long duct runs, elbows, and transitions

will reduce the performance of the hood.

Use as few of them as possible. Larger

ducting

may

performance with longer duct runs.

4. Attach an adequate length of

adapter.

5. The air must not be discharge into a flue that is used for exhausting

fumes from appliances burning gas or other fuels" "Regulations

concerning the discharge of air have to be fulfilled.

6. Install a roof/wall cap. Connect round metal ductwork to cap and

work back towards hood location. Use duct tape to seal the joints

between ductwork sections.

Electrical Connection

* Electrical wiring must be done by a qualified person(s) in

accordance with all applicable codes and standards. Turn off

electrical power at service entrance before wiring.

* If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent or similarly qualified persons in order

to avoid a hazard.

* Do not use the plug and an extension cord other than the ones

initially supplied with the hood.

* The earthing of this hood is compulsory. Do not remove ground

prong of the plug.

required

for

160mm round duct to the air outlet

best