Whirlpool AKR600IX Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Okap wentylacyjny Whirlpool AKR600IX. Whirlpool AKR600IX 14 stron. T-box decorative cooker hood

Drukuj stronę

RECOMMENDATIONS AND SUGGESTIONS

INSTALLATION

* The manufacturer will not be held liable for any damages resulting from incorrect or

improper installation.

* Please read this instruction manual before installing and using this cooker hood.

Properly keep this instruction manual in a safe place for future reference.

* This cooker hood can be used either in the Ducted Mode (ducting fumes to the

outside) or in the Recirculation Mode (internal recycling). The choice of modes can

be left to customers.

* Only a qualified and trained service technician can undertake the work of installation

and servicing.

* Check that the mains voltage corresponds to the one indicated on the rating plate

fixed inside the hood.

* Check that the domestic power supply guarantees adequate earthing.

* Do not connect the hood to exhaust ducts carrying combustion fumes (boilers,

fireplaces, etc.)

* If the hood is used in conjunction with non-electrical appliances (e. g. gas burning

appliances), a sufficient degree of ventilation must be guaranteed in the room in order

to prevent the backflow of exhaust gas. The kitchen must have an opening directly

with the open air in order to guarantee the entry of clean air.

* The minimum distance is 750mm from the cooker hood to a gas hob, and is 650mm

to an electric hob. If the installation instructions for gas hobs specify a greater distance,

this must be taken into account.

NOTICE: Considering excessive weight, two or more people are required to install or

move this appliance. Failure to do so can cause physical injuries.

USE

* The cooker hood has been designed only for domestic use to eliminate kitchen

fumes.

* Never use the hood for purposes other than what it has been designed for.

* Never leave high naked flames under the hood when it is in operation.

* Adjust the flame intensity to direct it onto the bottom of the pan only; making sure

that it does not engulf the pan sides.