Whirlpool GZ7730XGS1 Instrukcje instalacji oraz instrukcja obsługi i konserwacji - Strona 4
Przeglądaj online lub pobierz pdf Instrukcje instalacji oraz instrukcja obsługi i konserwacji dla Okap wentylacyjny Whirlpool GZ7730XGS1. Whirlpool GZ7730XGS1 36 stron. 30" (76.2 cm) and 36" (91.4 cm) slide-out vent range hood
Również dla Whirlpool GZ7730XGS1: Lista części (4 strony)
Drukuj stronęINSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
Tools needed
•
Level
•
Drill
•
11/4"drill bit
•
%" (8 mm) nut driver or ratchet
•
Pencil
•
Pliers
•
Wire stripper or utility knife
•
Tape measure or ruler
•
Caulking gun and weatherproof
caulking compound
•
Phillips screwdriver
•
Flat-blade screwdriver
•
Saber or keyhole saw
•
Vent clamps
•
Metal snips
Parts supplied
Check that all parts are included.
•
Literature package
•
2 screws
•
Damper
•
Plastic cover (used for customized front panel)
•
Hardware package
Parts needed
•
Two 1/2"(12.7 mm) UL listed or CSA approved conduit
connectors
•
Wall cap
•
Metal vent system
•
Power supply cable
Optional parts needed:
•
Wood filler strips for cabinets with recessed bottoms. Length
and thickness determined by recess dimensions. See
"Prepare Location" section.
•
Two, 1" x 1" x 5" (25.4 x 25.4 x 127 mm) wood pieces for
cabinet floor. See "Prepare Location" section.
•
Four, 11/4"(31.8 mm) wood screws
IMPORTANT: Observe all governing codes and ordinances.
•
Have a qualified technician install the range hood. It is the
installer's responsibility to comply with installation clearances
specified on the model/serial rating plate. The model/serial
rating plate is located behind the left filter on the rear wall of
the vent hood.
•
Range hood location should be away from strong draft areas,
such as windows, doors, and strong heating vents.
Cabinet opening dimensions that are shown must be used.
Given dimensions
provide minimum clearance. Consult your
cooktop/range
manufacturer
installation instructions
before
making any cutouts.
•
Grounded electrical outlet is required. See "Electrical
Requirements"
section.
•
The hood is factory set for vented installations through the
roof or wall.
For non-vented installations,
Recirculation
Kit Part
No. 883140 is available from your dealer or an authorized
parts distributor.
•
All openings in ceiling and wall where range hood will be
installed must be sealed.
For Mobile Home Installations
The installation of this range hood must conform to the
Manufactured
Home Construction
Safety Standards, Title 24
CFR, Part 328 (formerly the Federal Standard for Mobile Home
Construction
and Safety, title 24, HUD, Part 280) or when such
standard is not applicable, the standard for Manufactured
Home
Installation 1982 (Manufactured
Home Sites, Communities
and
Setups) ANSI A225.1/NFPA 501A*, or latest edition, or with local
codes.