Whirlpool UXD8630DYS Instrukcje instalacji oraz instrukcja obsługi i konserwacji - Strona 11
Przeglądaj online lub pobierz pdf Instrukcje instalacji oraz instrukcja obsługi i konserwacji dla Okap wentylacyjny Whirlpool UXD8630DYS. Whirlpool UXD8630DYS 36 stron. 30 76.2 cm and 36 91.4 cm retractable pop-up downdraft vent system
Również dla Whirlpool UXD8630DYS: Instrukcje instalacji oraz instrukcja obsługi i konserwacji (44 strony), Instrukcja instalacji, użytkowania i pielęgnacji (40 strony)
Drukuj stronę
Left or Right Venting:
1. Using two or more people, place the downdraft vent system
on its back.
2. Remove the 4 screws from the cover plate mounted to the
face of the motor box and set them aside.
A
B
C
D
A. Cover plate
B. Cover plate screws (4)
C. Cover plate keyhole slot shoulder
screws (4)
3. Slide the cover plate up and slip it over the keyhole slot
shoulder screws. Set the cover aside.
4. Remove 4 screws from the bottom of the motor box that hold
the motor assembly to the motor box.
NOTE: Disconnect the electrical wiring connection from
motor if needed.
5. Remove 3 screws and the vent cover plate from the left or
right side of the motor box for the venting direction to be
used.
6. Rotate the blower motor assembly 90 degrees to the left or
right side to the chosen venting direction and secure to the
blower box with motor mounting screws previously removed.
Do not twist or bind the wires.
7. Install the vent cover plate over the rectangular opening in the
bottom of the motor box and secure with vent cover screws.
NOTE: Reinstall the electrical wiring connection to motor if
removed.
8. Reinstall the cover plate to the face of the motor box and
secure with 4 cover plate screws previously removed.
9. For mounting the blower motor to the back of the vent box,
go to the "Rear Mounting—Blower Motor" section.
Otherwise, go to the "Complete Installation" section.
G
F
E
D. Motor mounting screws (4)
E. Vent cover plate
F. Motor box
G. Vent cover screws (3)
Rear Mounting—Blower Motor
NOTE: Optional blower motor rear mounting position (opposite
side) for island cabinet locations. The blower motor box
assembly can be moved to the opposite side (rear) of the vent
box.
1. Remove 7 screws from the mounting flanges of the blower
motor box.
Front View
A
C
A. Screws (7)
B. Keyhole slot shoulder screws (2)
C. Blower motor box
2. Lift blower motor box off the shoulder screws in the keyhole
slots. Disconnect wire connection from blower motor and set
blower motor box aside.
3. Remove 6 screws from the mounting flange of the
¼" (6.4 mm) deep cover.
Rear View
C
A. Screws (6)
B. Keyhole slot shoulder screws (2)
C. ¼" (6.4 mm) deep cover
A
A
B
A
B
11