Whirlpool UXL5430BSS1 Instrukcje instalacji oraz instrukcja obsługi i konserwacji - Strona 12

Przeglądaj online lub pobierz pdf Instrukcje instalacji oraz instrukcja obsługi i konserwacji dla Okap wentylacyjny Whirlpool UXL5430BSS1. Whirlpool UXL5430BSS1 16 stron.

Drukuj stronę

The range hood is designed to remove smoke, cooking vapors

and odors from the cooktop area. For best results, start the hood

before cooking and allow it to operate several minutes after the

cooking is complete to clear all smoke and odors from the

kitchen.

The hood controls are located on the center of the front of the

range hood liner.

A. Blower and light controls

B. Grease filter

C. Grease filter handle

D. Halogen lamp housings

IMPORTANT: Clean the hood and grease filters frequently

according to the following instructions. Replace grease filters

before operating hood.

Exterior Surfaces:

To avoid damage to the exterior surface, do not use steel wool or

soap-filled scouring pads.

Always wipe dry to avoid water marks.

Cleaning Method:

Liquid detergent soap and water, or all-purpose cleanser

Wipe with damp soft cloth or nonabrasive sponge, then rinse

with clean water and wipe dry.

RANGE HOOD USE

RANGE HOOD CARE

Cleaning

Range Hood Controls

A. On/Off light button

B. Blower off and speed minimum button

C. Blower speed medium button

D. Blower speed maximum button

Operating the Light

The On/Off light button controls all lights. Press once for On and

again for Off.

Operating the Blower

The Blower Speed buttons turn the blower on and control the

blower speed and sound level for quiet operation. The speed can

be changed anytime during fan operation by pressing the desired

blower speed button.

Press the Blower Off button a second time to turn off the blower.

Metal Grease Filter

The filters should be washed frequently. Place metal filters in

dishwasher or hot detergent solution to clean.

Let filter dry thoroughly before replacing it.

Turn off fan and lights. Allow halogen lamp to cool.

1. Remove each filter by pulling the spring release handle and

then pulling down the filter.

A. Spring release handle

2. Wash metal filters as needed in dishwasher or hot detergent

solution.

3. Reinstall the filter by making sure the spring release handles

are toward the front. Insert metal grease filter into upper

track.

4. Pull the spring release handle down.

5. Push up on metal filter and release handle to latch into place.

6. Repeat steps 1-5 for the other filter.